CenturionPro BUCKER Manual do Proprietário - Página 6
Procurar online ou descarregar pdf Manual do Proprietário para Acessórios CenturionPro BUCKER. CenturionPro BUCKER 8 páginas.
Imprimir página
ASSEMBLY
STEP 1
CONNECT THE CONVEYOR BED AND THE CONVEY-
OR LEGS AS FIGURE ILLUSTRATES. MAKE SURE THAT
THE CONVEYOR BED IS CENTERED ON THE CONVEY-
OR LEGS. TIGHTEN BOLTS AND NUTS TOGETHER.
3/16" T-HANDLE ALLEN WRENCH.
9/16" WRENCH.
STEP 2
INSTALL CONVEYOR GUARDS TO TOP OF CONVEYOR
SIDE RAILS AS SHOWN. THE NUTS REQUIRED ARE
IN TOP SLOT OF CONVEYOR RAIL. TO RETRIEVE, RE-
MOVE BLACK END CAP FROM END OF THE RAIL AND
SLIDE NUTS INTO PLACE.
STEP 3
ENSURE THAT ALL BOLTS ON CONVEYOR AND CONVEYOR
LEGS ARE TIGHT USING WRENCH AND ALLEN WRENCH.
3/16" T-HANDLE ALLEN WRENCH.
9/16" WRENCH.
BELT ADJUSTMENT
ADJUSTING THE BELT TENSION PROPERLY WILL ENSURE THE BELT IS RUNNING STRAIGHT. AFTER CLEANING OR MAINTENANCE TIGHTEN
TENSIONER BOLTS EVENLY ON THE END OPPOSITE THE MOTOR UNTIL THE BELT IS SLIGHTLY SAGGING UNDERNEATH. SIMPLY TIGHTENING
YOUR TENSIONERS EQUALLY UNTIL THE BELT DOES NOT SLIP ON THE DRIVE PULLEY IS SUFFICIENT FOR TENSIONING THE BELT. ROTATING
THE TENSIONER BOLT CLOCK-WISE WILL TIGHTEN THE BELT, COUNTER CLOCK-WISE WILL LOOSEN.
DICULAR TO THE SIDE RAILS AND PARALLEL TO EACH OTHER TO ENSURE PROPER ALIGNMENT.
NOTE: UNDER TENSIONING AND OVER TENSIONING CAN CAUSE THE BELT TO SLIP.
STEP 1 - TRACKING
IF THE BELT IS TRACKING TOWARDS THE
MOTOR SIDE RAILS, RUN THE CONVEYOR
SLOWLY AND TIGHTEN THE MOTOR SIDE
TENSIONER BOLT 1/4 TURNS UNTIL THE
BELT STARTS TO TRAVEL AWAY FROM THE
RAIL. LOOSEN SLIGHTLY TO STOP THE BELT
FROM TRACKING IN OPPOSITE DIRECTION.
IMPORTANT:
UNDER TENSIONING
AND OVER TENSIONING
CAN CAUSE BELT TO SLIP
1 855 535 0558
6
1
2
STEP 2 - TRACKING
IF THE BELT IS TRACKING TOWARDS THE
NON-MOTOR SIDE RAILS, TIGHTEN THE
NON-MOTOR SIDE TENSIONER BOLT
1/4 TURNS UNTIL THE BELT STARTS TO
TRAVEL AWAY FROM THE RAIL. LOOS-
EN SLIGHTLY TO STOP THE BELT FROM
TRACKING IN THE OPPOSITE DIRECTION.
MOTOR
TENSIONER BOLTS
cprosolutions.com
CONVEYOR
THE TWO ROLLERS SHOULD BE PERPEN-
1
2
TIGHTEN
TIGHTEN