Gamry Instruments IMX8 Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Multiplexador Gamry Instruments IMX8. Gamry Instruments IMX8 4 páginas.

Connect Power Adapter and USB Cable

On the rear side of your IMX8 Multiplexer is the Power In connector located which connects to the

supplied AC Adapter with its male 3-pin DIN connector. The other end of the power supply connects to an

AC line cord which can be plugged into your AC Mains supply. The power supply is rated for operation from

100 to 240 V AC and 47 to 63 Hz. It should therefore be universally useful.

Note: Use only Gamry-approved power adapters with your IMX8 Multiplexer. Other power sources may alter

the performance and safety characteristics of your IMX8 Multiplexer.

Your IMX8 Multiplexer is supplied with a standard High Speed USB A/B cable. Connect the nearly square

connector to the USB connector on the rear side of your IMX8. The other end, a wider, rectangular connector

plugs into a USB port on your computer.

Test your IMX8 Multiplexer in Gamry Framework

1) Make sure that your computer and IMX8 Multiplexer are turned on.

2) Open the Framework software and choose Experiment > Utilities > Multiplexer Con�gure and Test.

3) Select the function Mux Test and choose the Multiplexer to test.

4) Verify that all eight amber LEDs on the front of the IMX8 illuminate in sequence two times.

Set channel state of your IMX8 Multiplexer

1) Make sure that your computer and IMX8 Multiplexer are turned on.

2) Open the Framework software and choose Experiment > Utilities > Multiplexer Con�gure and Test.

3) Select the function Set Channel and choose the Multiplexer.

4) Turn on/oﬀ individual channels, set their potential state, or specify an active channel.

Note: Only the amber LED of the channel that is currently running is illuminated.