IKEA ID5HHEXVS05 Instruções para o utilizador - Página 11
Procurar online ou descarregar pdf Instruções para o utilizador para Frigorífico IKEA ID5HHEXVS05. IKEA ID5HHEXVS05 29 páginas. Whirlpool
Imprimir páginaCut Hazard
Use a sturdy glass when dispensing
ice.
Failure to do so can result in cuts.
Is the ice dispenser stalling while dispensing "crushed"
ice? Change the ice button from "crushed" to "cubed." If
cubed ice dispenses correctly, depress the button for
"crushed" ice and begin dispensing again.
Has the dispenser arm been held in too long? Ice will stop
dispensing when the arm is held in too long. Wait 3 minutes
for dispenser motor to reset before using again.
The water dispenser will not operate properly
•
Freezer door closed completely? Close the door firmly. If it
does not close completely, see "The doors will not close
completely."
Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
Is the water pressure
at least 30 psi (207 kPa)? The water
pressure to the home determines the flow from the dispenser.
See "Water Supply Requirements."
Kink in the home water source line? Straighten the water
source line.
•
New installation? Flush and fill the water system.
•
Water filter installed
on the refrigerator?
The filter may be
clogged or incorrectly installed.
•
Is a reverse osmosis
water filtration
system connected
to
your cold water supply? See "Water Supply Requirements."
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
•
Glass not being held under the dispenser
long enough?
Hold the glass under the dispenser for 2 to 3 seconds after
releasing the dispenser lever/pad.
New installation? Flush the water system. See "Prepare the
Water System" or "Water and Ice Dispensers."
Recently changed water filter? Flush the water system. See
"Prepare the Water System" or "Water and Ice Dispensers."
The dispenser
water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
•
New installation?
Allow 24 hours after installation for the
water supply to cool completely.
•
Recently dispensed
large amount of water? Allow 24 hours
for water supply to cool completely.
•
Water not been recently dispensed?
The first glass of water
may not be cool. Discard the first glass of water.
•
Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements."
ACCESSORIES
To order replacement filters, call 1-866-664-2449
and ask for the
part number listed below or contact your authorized Whirlpool
dealer.
Stainless Steel Cleaner and Polish:
Order Part #4396095
Standard Base Filter Cartridge:
Order Part #4396508 (NL240/L400)
WATERFILTER
CERTIFICATIONS
State of California
Department
of Health Services
Water Treatment Device
CertificateNumber
03- 1550
Date Issued:
January
21,2003
Trademark/Model
Designation
Replacement
Elements
Rated Ca_
Whm_ool
WI:-NL24(
NL240
240 gal
Whir tpt_t_l WF-I_4(X)
100
400 Izal
Manufacturer:
Whirlpool
(2ol 3 )
None
Organic
Contaminants
Lead
Nate(t
Set'rice
Flow:
05gpm
Do not use with water
that is microbiologically
ansafe
or of unknown
quality,
without
adequate
disinfection
before
or after
the _ysrem.
11