ENGLISH
What to do if ...
What to do if...
The control panel is switched off,
the appliance does not work.
The inside light does not work.
The temperature inside the
compartments is not low enough.
There is water on the bottom of the
refrigerator compartment.
The front edge of the appliance, at
the door striker seal, is hot.
The red light
flashes and an
acoustic alarm sounds.
Possible causes:
The appliance could be in
On/Standby mode.
There may be an appliance
power supply problem.
The light may need
replacing.
The appliance could be in
On/Standby mode.
There could be various
causes (see "Solutions").
The defrost water drain is
blocked.
This is not a defect. It
prevents condensation from
forming.
Door open alarm
Activated when a door
remains open for a long
period of time.
Solutions:
Activate the appliance with the
On/Standby button.
Make sure:
- there is not a power outage
- the plug is properly inserted in
the power socket and the mains
double-pole switch (if present) is
in the correct position (i.e. allows
the appliance to be powered)
- the household electrical system
protection devices are efficient
- the power cable is not broken.
Models with lamp: disconnect the
appliance from the power supply,
check the lamp and, if necessary,
replace it with a new one (see the
section "Changing LED"). Contact
the After Sales Service.
Activate the appliance with the
On/Standby button.
Make sure:
- the doors close properly
- the appliance is not installed
near a heat source
- the set temperature is adequate
- the circulation of air through
the vents at the bottom of the
appliance is not obstructed.
Clean the defrost water drain
hole (see the section "Appliance
Maintenance and Cleaning").
No remedy is necessary.
Close the doors of the product to
deactivate the acoustic alarm.
If the acoustic alarm does not go
off it is a power failure alarm (see
the section Power failure alarm).
13
Imprimir página