Century Helicopter Products Predator Max 90 Manual de instruções - Página 15

Procurar online ou descarregar pdf Manual de instruções para Brinquedo Century Helicopter Products Predator Max 90. Century Helicopter Products Predator Max 90 20 páginas.
Também para Century Helicopter Products Predator Max 90: Manual de instruções (20 páginas)

Imprimir página

Century Helicopter Products Predator Max 90 Manual de instruções

#CNLR1013 x 2 Short Steel Ball

#CNBB410 x 2

#HW3098A Steel

Tail Rotor Hub

#CNBB49T x 2

#CNLR1003 M3x5x0.5

Micro Washer

Press the M4 bearing into the end, slide the M3 thrust

bearing (in correct order), micro washer, M3 bearing and

locknut from inside the grip. Use locktight on the locknut.

M3 Locknut x 2

M3x10x1.5

Spacers x 4

#CN260956 Rotortech 95mm Tail Blades - SE

#CN261056 Rotortech 105mm Tail Blades - Max 90

Tail rotor blades are installed with the leading edge rotating

upwards into the downwash of the main blades. Looking at

the left side of the Predator, the blades turn clockwise with

the steel ball on the leading edge.

Locknuts

face

outside.

Install the tail rotor blades to the tail rotor grips with the M3

shoulder socket cap screws, M3 spacers on both sides the the

blades and secured with M3 locknuts, fitted into the molded

recess on the tail blade grips.

#HI3096A Tail

Grips x 2

M3 Locknut x 2

#CNBB0930

x 2

#HI6099 Tail Rotor

Blades - 60/70

#HW6001 M3x18 Shoulder

Socket Screw x 2

#CNLR1014

Short Steel

Ball

Completed tail

gearbox assembly.

M3x4 Set Screw

Tail rotor

assembly

Insert tail rotor grip assembly onto the tail output shaft,

aligning the set screw over the indent in the shaft using

locktight. Attach the tail pitch ball links to the balls, the steel

ball is on the leading edge of the blades.

The carbon tail blades will not fit the tail rotor grips without

trimming the ends. Attach the two blades together and grind

3-4mm off the end of the blades as shown.

M3x10 Flat Head

Insert the front of the tail boom into the front tail transmis-

sion half and close the transmission. Secure with M3 socket

screws locknuts. Attach the tail boom assembly to the

mechanics with M3x8 screws first then the Flat head screws.

Attach first, then remove and locktight all the screws.

Bolt both blades

together.

Grind 3-4mm

off end.

M3x12 Socket

Screw x 2

Screw x 4

& M3 Lock-

M3x8 Socket Screw x 4

nut x 4