KitchenAid KGCT305BWH0 Manual de instruções de instalação - Página 2
Procurar online ou descarregar pdf Manual de instruções de instalação para Placa de fogão KitchenAid KGCT305BWH0. KitchenAid KGCT305BWH0 9 páginas. 30” (76.2cm) and 36” (91.4cm) gas sealed burner glass cooktops
30" (76.2cm) Cooktop
Width - 30-3/4" (76.lcm)
30" (76.2cm) min. base cabinet
is required. If
cabinet has a drawer, a 3-112" (8.9cm) depth
clearance from the countertop to the top of the
drawer (or other obstruction)
in base cabinet is
required.
36" (91.4cm) Cook-top
Width -
36" (91.4cm)
36" (91.4cm) min. base cabinet
is required.
If
cabinet has a drawer, a 3-l/2" (8.9cm) depth
clearance from the countertop to the top of the
drawer
(or other obstruction)
in base cabinet is
required.
Fire Hazard
Do Not obstruct
the flow of combustion
and ventilation
air.
Personal
Injury Hazard
Avoid installing
cabinet
storage
above the
cooking
surface.
If cabinets
are already
installed,
reduce the hazard of reaching
over a heated cooking
surface by
installing
a range hood. The range hood
should extend a minimum
of 5 inches
(12.7cm) out from the bottom front of the
cabinets.
Reaching
over a heated cooking
surface
could result in a serious
burn or other
personal
injury.
Electrical
Shock Hazard
It is the customer's
responsibility:
l
To contact
a qualified
electrical
installer.
l
To assure that electrical
installation
is
adequate
and in conformance
with
National
Electrical
Code, ANSVNFPA
70
-
latest edition",
or Canadian
Electrical
Code, C22.1 -1982 and C22.2 No. 01982
(or latest edition) ** and all local codes
ands ordinances.
Failure to do so could result in fire,
electrical
shock or other personal
injury.
Take special care when drilling
holes into
the wall for electrical
wiring.
Electrical
wires may be concealed
behind the wall
covering.
Failure to do so could result in fire,
electrical
shock or other personal
injury.
I
For 30" (76.2cm)
cooktop
- 30' (76.2cm)
min. cabinet
width above cooktop
For 36" (91.4cm)
cooktop
- 36" (91.4cm)
min. cabinet
width above cooktop
Y
::3.0cm)
max.
a
up.pr
I
See Note"
for
minimum
clearances
(12.7cm)
below
countertop
and
15" (36.lcr;l)
max.
from bottom
of
countertop
I"rr.,
--.-
".,..."_..
. ..-
cooktop
and cabinets.
l
Note: 30" (76.2cm)
min. when bottom of wood or
metal cabinet is protected by not less than
l/4"
(km)
flame retardant millboard covered with
not less than No. 28 MSG sheet steel, 0.015"
(.04cm) stainless steel, 0.024" (.06cm) aluminum
or 0.020" (.05cm) copper.
36" (91.4cm) min. clearance between the top of
the cooking platform and the bottom of an
unprotected wood or metal sheet.
\':-----'
mm.
18-X/16"
(48.lcm)
min. openmg depth
27-3/l 6" (69.1 cm)
min. opening width
2-5/S" (6.7cm) min.
cabinet space to
backsplash or
vertical wall
5-114" (13.3cm)
min. cabinet space
both sides of
cooktop from a
combustible
surface
l&15/16"
(48.lcm)
min. openmg
depth
33-7/16" (84.9cm)
min. opening width
2-5/8" (6.7cm) min.
cabinet space to
backsplash or
vertical wall
5-l/4" (13.3cm)
min. cabinet
space both sides
of cooktop from a
combustible
surface
Before you start...
WARNING: If the information
in this manual is not followed
exactly, a fire or explosion
may result causing property
damage, personal injury or
death.
1
- Do Not store or use gasoline
or other flammable vapors
and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL
GAS
l
Do Not try to light any
appliance.
l
Do Not touch any electrical
switch; do not use any phone
in your building.
l
Immediately call your gas
supplier from a neighbor's
phone. Follow the gas
supplier's instructions.
l
If you cannot reach your gas
supplier, call the fire
department.
- Installation and service
must be performed by a
qualified installer, service
agency or the gas supplier.
-
Proper installation
is your responsibility.
Make
sure you have everything
necessary for correct
installation.
It is the responsibility
of the installer
to comply with the installation clearances
specified on the serial/rating
plate. The
serial/rating
plate can be found on the bottom of
the cooktop burner box.
Check location
where cooktop will be installed.
The location should be away from strong drafi
areas, such as windows. The cooktop should be
located for convenient
use in the kitchen.
ALL OPENINGS
IN THE WALL OR FLOOR
WHERE THE COOKTOP
IS TO BE INSTALLED
MUST BE SEALED.
Grounded
electrical
outlet is required. See
"Electrical requirements."
Proper gas supply
connection
must be
available. See "Gas supply requirements."
Countertop
opening
dimensions
that are
shown must be used. Given dimensions provisde
required 0" (.Ocm) clearance.
Cabinet construction:
This appliance is
designed for use in a base cabinet with a depi h
of 24" (61 .Ocm). The maximum depth for
overhead cabinets is 13" (33.0cm). The minirnum
vertical clearance between the cooking surface
and the overhead cabinets is 30" (76.2cm).
Overhead cabinets installed at either side of the
appliance must be a minimum of 18" (457cm)
above the cooking surface. The minimum
distance between the front edge of the
countertop and the front edge of the cooktop is
3/4" (1.9cm). The minimum horizontal distance
between the overhead cabinets above the
appliance are shown for your model number.
New installations
-follow
minimum
dimensions given.
Replacement
installations
-
Be sure that fr'ont
edge of cooktop is at least 1 -l/2" (3.8cm) back
from front edge of countertop.
When installing
cooktop
over a built-under
oven. Do Not fasten cook-top to countertop with
clamps. Cooktop then will be easy to remove if
servicing is ever necessary.
Note: The sealed gas cooktop is manufactured
for use with NATURAL gas. Conversion to L.F'.
gas can be made with Kit No. 4173627, available
from your KitchenAid dealer or authorized pan:s
distributor.
Important:
Observe
all governing
codes and
ordinances.
Failure to meet codes and
ordinances
could lead to fire or electrical
shock.
**National
Fire Protection
Association
Batterymarch
Park
Quincy,
Massachusetts
02269
***Canadian
Standard
Association
178 Rexdale
Boulevard
Rexdale
(Toronto),
Ontario
M9W 1 R3
Minimum
distance
to nearest side and
rear combustible
surface above
countertop
Panel A