IKEA GRILJERA Manual do utilizador - Página 26

Procurar online ou descarregar pdf Manual do utilizador para Campânula de ventilação IKEA GRILJERA. IKEA GRILJERA 36 páginas.
Também para IKEA GRILJERA: Manual do utilizador (16 páginas), Manual (16 páginas)

Imprimir página

ENGLISH

Gas connection

WARNING! This appliance shall be installed

only by authorised personnel and in accordance

with the manufacturer's installation instructions,

local gas fitting regulations municipal building

codes, water supply regulations, electrical wiring

regulations, AS 5601 - Gas Installations and any

other statutory regulations.

The appliance is adjusted to work with the gas

indicated on the label which is applied on the

glass-window of the oven door and on the

cooker packing.

Installation for Natural gas

Connect regulator (B) to fitting (A) which is then

fitted to gas inlet (E). Ensure arrow on regulator

point in the direction shown. Fitting (D) to be

supplied by installer (fig. 1). Adjiust regulator to

give test-point pressure given on data label on

INJECTOR TABLE paragraph, with one large or

one medium burner alight at maximum.

Position of Regulator (fig. 1).

The cooker must be installed on legs which come

with the product, a gas pipe between fitting (A)

and (B) will allow location of the regulator (B)

underneath the stove for adjustment and

maintenance.

Installation for UNIVERSAL LPG (fig. 2)

"Connect the Test Point (A), from the threaded

fitting of the Cooker Gas Inlet (E).

Connect gas line by using a copper pipe.

Installation using flexible connection.

As an option, the cooker may be installed with

flexible connection hose, which complies with

AS/NZS 1869 (AGA Approved), 10 mm ID, class

B or D, Minimum 1000 mm - Maximum 1200 mm,

as an alternative connection.

IMPORTANT:The manifold has a flat flair

over which is inserted a screw nut male 1/2" gas

(fig. 3)

An isolating tap and pressure regulator must

be fixxed to the rear wall and the flexxible

piepe attached by means of a union

connector.

The gas connection and isolating tap must

be accessible to a service person or

inspector.

The hose assembly must be installed in

accordance with AS5601 for a high level

connection. The hose should not be

subjected to abrasion, kinking or permanent

deformation and should be able to be

inspected along its entire length. Unions

compatible with the hose fitting must be

used and connections tested for gas leaks.

The fixed consumer piping outlet should be

at approximately the same height as the

cooker connection point, pointing

downwards.

The hose should be clear of the floor when

the cooker is in the installed position. The

antitilting chain supplied should be anchored

to the lower hook fixed to the wall so that the

chain prevents strain on the hose connections

when the cooker is pulled forward.

IMPORTANT: When the regulator is fitted

at the rear of the cooker at least 60 mm

clearance is required.

Fig. 1

Fig. 2

Fig. 3