Ganz ZC-DT4312 PHA Manual de operação - Página 4

Procurar online ou descarregar pdf Manual de operação para Câmara de segurança Ganz ZC-DT4312 PHA. Ganz ZC-DT4312 PHA 4 páginas. Mini dome color camera; vandal resistant dome camera

Imprimir página

Installing the dome enclosure

1. Remove the dome cover

Use the supplied Torx driver to loosen (but not remove) the four cover screws.

The screws are captive and will be retained in the lid.

2. Use the template to mark and prepare the mounting area

The vandal resistant dome was designed to maintain their IP and NEMA ratings

independent of the install method chosen. Therefore, all mounting access positions

are sealed until they are ready to be used. For example, when surface-mounting the

housing, first knock out the screw access holes that correspond to the template marks

"T1". This can be done using a crosshead screwdriver.

3. Open the required knock-out panel

Carefully drill (or tap out) either the base knock-out (E1) or internal side knock-out

(E3) to the size required to allow cable entry. When surface mounting and using the

side knock-out (E3), open the cut out (E4) within the outer ring to the required size

by cutting away excess material with a hole cutter, sharp knife or side cutters.

4. Mount the dome enclosure

Using one of the mounting schemes discussed overleaf (methods for mounting the

enclosure), fix the dome enclosure (and outer ring, if necessary) in place. When flush

mounting or surface mounting using the outer ring,

ensure that the large rubber gasket (E6) is in place

under the lip of the dome enclosure.

IMPORTANT: If the dome is being mounted

externally using the four base holes, use the supplied

rubber o-rings within each of the four mounting holes

of the dome base to ensure moisture resistant seals

(see Fig. C overleaf).

5. Connect the wiring

Feed the preconnected main lead (that terminates in

connections F1 and F2) through the knock-out hole

and connect it to your video out and power in cables. A wire-ended adaptor lead (F8)

is supplied for use with power supply cables that are not terminated with an

appropriate power connector (For 12 VDC operation: Connect the red lead to +ve and

the black lead to -ve. For 24 VAC connection, polarity is not important).

IMPORTANT: The power supply must be Class 2 certified.

IMPORTANT: If the dome is being mounted externally, use a suitable sealant around

the cable access hole to ensure a moisture resistant seal.

6. Fit the camera assembly

Connect the camera to the fly-connector (F4). For ZC-DWT4039 series camera only:

also connect the OSD lead (F6) between the camera and the middle socket of the

smaller circuit board. Place the complete camera assembly (G1) onto the three

mounting pillars within the enclosure.

Note: Gimbal screws are supplied with both the housing and the camera assembly

(when supplied separately), therefore, you should have three screws left over.

7. Remove the camera liner

Lift the camera liner (H1) from the chassis (H2) to provide full access to the camera.

8. Adjust the camera position and test

Rotate and pan the camera chassis to the required position and then tighten the

camera chassis locking screws. Note: For specific camera adjustments (i.e. focusing

and settings), please see the Camera Sheet.

9. Replace the camera liner

Carefully fit the camera liner (J1) over the focused camera so that it is fully seated on

the top ring of the camera chassis (J2) and provides an unobstructed view for the

camera lens.

10. Replace the dome cover

Replace the dome cover (four small internal ribs within the cover locate within four

corresponding index slots (E6) within the enclosure body; these restrict the lid to only

four possible orientations and ensure that the cover screw holes are correctly aligned).

Use the supplied Torx bit to tighten the four cover screws

- DO NOT OVERTIGHTEN.