KitchenAid DISHWASHER Manual de instruções de instalação - Página 3
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça KitchenAid DISHWASHER. KitchenAid DISHWASHER 6 páginas. Drawer dishwasher
Também para KitchenAid DISHWASHER: Instruções para o utilizador (20 páginas), Instruções para o utilizador (5 páginas), Instruções para o utilizador (10 páginas)
Imprimir página
Vow start...
With washer In laundry area.
.flOQO
S
Pull the stra>
\
1
n
Remove tape that covers shipping strap.
Pull to completely remove the shipping
strap from the inside of the washer.
Pull llrmly IO remove the olher end ot
shipping strap from the back of the
washer. The shipping strap plug must be
completely removed from the washer for
the selt-leveling legs IO be released.
Save the shlpplng strap for use In
Step 17.
2
Read, then remove label that
W covers power cord and drain
connector. Peel the tape down and ott
each side 01 cabinet.
Use new hos'es and washers lhal came
with your washer.
.
Insert a llat washer Into each end of the
inlet hoses. Check that washers are firmly
;eated in couplings.
IIC.
r
4
Attach hose to bottom Inlet valve
n opening first; then second hose tc
top inlet. Tighten couplings by hand.
Then use pliers to make an additional
two-thirds turn.
5
Place hose
n clamp over
washer drain
connector. Push
coupling end 01 drain
hose onto washer
connector. Use
pliers to open clamp
and slide clamp over
drain hose. Check
tor good tit.
Numbers
corresoond
to
Floor Damage
Slide washer onto cardboard or
hardboard before moving acrose
1 floor.
Failure lo do so may cauo'e damage
to lloor coverlng.
I
7
Move washer close to llnal
W position, Put 'hook'end
of drain
hose Into laundry tub or standplpe. Check
for proper lenglh of draln hose.
8'
n
If drain hose
Is too long -
dtsconnect.
Remove clamp
and couplings.
Eslimate
length of drain
hose needed.
Cut flexible
end 01 hose.
(Do not cut hook-shaped
end 01 drain
hose,) Push and twist coupling securely
onto drain hose. (You should feel top of
tose thiough coupling.) Slide clamp over
:oupling and hose. Reinstall drain hose.
See Step 5.)
IO NOT FORCE EXCESS LENGTH OF
IRAIN HOSE DOWN THE STANDPIPE.
rHlS COULD CAUSE SIPHONING.
9
Before attaching water Inlet
m hose, run water through both
faucets Into a buckel. This will get rtd Ot
particles in the water lines that might clog
hoses.
10
Attach bottom hose (inlet
n marked -H") to hot waler
faucet. Attach top hose (inlet marked 'c')
to cold water faucet, Tighten couplings to
faucets by hand; then use pllen lo make
linal two-thirds turn.