Afrison Meru Instruções técnicas e de instalação - Página 2

Procurar online ou descarregar pdf Instruções técnicas e de instalação para Luz de inundação Afrison Meru. Afrison Meru 2 páginas. Led flood light

Imprimir página
Installation instruction
The installation must be carried out by a Qualified Electrician.
Tools required:
-
Flat head screwdriver (to open connection box.)
-
13 hex spanner (to adjust u-bracket) tools not included
1.
To install the Meru Flood Light, special attention needs to be given to the mounting holes on the U-bracket for alignment.
a.
Use correct size (calculated on hight and weight) Bolts / Rawle bolts to correspond with your mounting surface.
b.
Once U-bracket adjusted to required angle fasten U-bracket bolts. (M8 25N.m)
2.
To connect to the mains 220VAC confirm main power is switched off.
3.
The Meru Flood Lights require mains voltage of between 200 to 240VAC 50 Hz. Connect the mains cable to the protection unit via the
20mm Cable Gland. Always use round cable and not flex or flat cables for sealing purposes with the Cable Gland. Open the protection
unit by unscrewing the 4 screws that keep the lid closed. Connect the corresponding wires, Brown (L), Blue (N), and Yellow/Green (E)
in the connector on the PC board. Always read the label on the protection unit to make sure the voltage is correct. When powering
the light, the light should come on immediately.
4.
Connection Diagram:
5.
Picture of Protection Unit:
Meru LED
Flood Light
Protection Unit
*AFRISON TERMS & CONDITIONS
DUE TO ONGOING R&D AFRISON RESERVES THE
WITHOUT PRIOR NOTICE
1, 2 , 3 OR 5 YEAR WARRANTY (REPLACE OR REPAIR) - PLEASE SEE FULL TERMS AND CONDITIONS AT
SHOWN ARE FOR ILLUSTRATION PURPOSES ONLY, ACTUAL PRODUCT MAY VARY DUE TO TECHNICAL DEVELOPMENT. E & OE. © 2022 AFRISON LED. ALL RIGHTS RESERVED.
CATALOGUE AT ITS OWN DISCRETION AND AT ANY TIME
WWW.AFRISON.CO.ZA
- PICTURES