BriteLite M2000 Manual de operação - Página 3
Procurar online ou descarregar pdf Manual de operação para Altifalantes BriteLite M2000. BriteLite M2000 4 páginas. Professional abs molded loudspeaker
Imprimir página
Bluetooth Connection
1. Make sure device (iPod, MP3 player, etc.) Bluetooth function is enabled. Remove SD Card or USB
stick from speaker before enabling Bluetooth.
2. On the speaker, press and hold menu (4) button for 2-3 seconds to call up main menu. Press
NEXT (6) button to select Bluetooth function and press MENU (4) button again to activate
Bluetooth. Your device and speaker should now be connected.
3. Make sure to choose BLUETOOTH from your device to complete the connection
4. Only one Bluetooth device can be connected to the M2000 speaker at a time.
5. To connect a new device; turn off the M2000 speaker for 10 seconds and turn on again and begin
with step one above.
Placement Tips
Avoid placing loudspeakers in the corners of a room. This increases the low-frequency output and can
cause the sound to be muddy and indistinct.
Avoid placing loudspeakers against a wall. This, too, increases the low frequency output, though not as
much as corner placement. However, if you do need to reinforce the low frequencies, this is a good way
to do it.
Avoid placing the active speakers directly on a hollow stage floor. A hollow stage can resonate at
certain frequencies, causing peaks and dips in the frequency response of the room. It's better to place
the speakers on a sturdy table or tripod stands.
Position the speakers so the high-frequency drivers are two to four feet above ear level to the audience
to maintain high frequency quality.
Troubleshooting
No Power
First check to make sure the speaker is plugged in to a live AC outlet.
Make sure the POWER switch is on.
No Sound
Make sure input LEVEL control turned up.
Make sure signal source is working and the connecting cables are in good shape and securely
connected at both ends. Make sure the output volume control on the mixing console is turned up.
Make sure the preamp or mixer does not have a Mute button engaged.
Bad Sound – Noise - Humming
If the sound is loud and distorted, verify that the levels are set properly on the speaker and mixing
console.
Make sure all connectors are secure and they are plugged in to the proper connecter (i.e., Mic cable
plugged in to MIC input, Line level source plugged in to Line Level Input.
It is a good idea to periodically clean all electrical connections with a non-lubricating electrical contact
cleaner.
OPERATIONS MANUAL – M2000
Professional ABS Molded Loudspeaker