KitchenAid KDIX 8810 Manual de instruções de instalação - Página 7
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça KitchenAid KDIX 8810. KitchenAid KDIX 8810 12 páginas.
Imprimir página
Installation instructions
PREPARE DISHWASHER
1. With a utility knife, cut along the back right
corner of inner carton.
Cut along
this corner
2. Remove inner carton. Leave dishwasher on
bottom pad.
3. Install tap unit (not included). The dishwasher is
shipped ready for installation of a one-hole tap
unit. If a two-, three-, four-hole faucet is to be
installed, the holes must be cut by a qualified
plumber according to the tap unit
manufacturer's specifications.
INSTALL DISHWASHER
1. Mark countertop and apply a 6÷7 mm bead of
silicone caulk 6÷7 mm away from dishwasher
cutout on sides and 11 mm on front and back.
6÷7 mm
bead of silicone
cault
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Back of
inner carton
dishwasher
cutout
IMPORTANT:
To prevent damage to right-hand hinge, open
dishwasher lid before setting dishwasher into
countertop cutout.
2. Set the dishwasher into countertop cutout.
Make sure front of dishwasher is parallel to
front edge of countertop.
3. After complete installation dishwasher should be
fully fixed by silicone. For additional support you
can use included clamps and brackets:
• Install two clamps, evenly spaced, on front
(sink) side clamp rail. To install clamps:
- hook upper clamp onto rail; use flat-blade
screwdriver to attach clamp to rail,
- use 11 mm deep-well socket and securely
tighten nut against lower clamp. Do not
overtighten.
rail
countertop
• Install two brackets on right bottom side of
dishwasher. To install brackets:
- use screwdriver with torx tip to attach bracket
to bottom of dishwasher,
- use cross-blade screwdriver to attach bracket
to cabinet.
7
sink
upper clamp
lower clamp