Briteq BEAMSPOT1-DMX WW Manual de operação - Página 9

Procurar online ou descarregar pdf Manual de operação para Equipamento de iluminação Briteq BEAMSPOT1-DMX WW. Briteq BEAMSPOT1-DMX WW 12 páginas.

ENGLISH

ELECTRICAL INSTALLATION

Important: The electrical installation should be carried out by qualified personal only,

according to the regulations for electrical and mechanical safety in your country.

Master / Slave mode:

Connect the projectors together as shown on the drawing. Please refer to the paragraph "SETUP MENU" to

setup the master. All slaves must be set to SLAVE-mode. You can put as many slaves as you like on

condition that the overall power consumption on the power line stays under 10A (2300W).

IMPORTANT: make sure that no DMX-controller is connected, this will result in unexpected behavior!

Electrical installation for two or more units in DMX-mode:

 The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to

"daisy chain" your DMX controller and all the connected units.

 Pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)

 To prevent strange behavior of the light effects, due to interferences, you must use a 90Ω to 120Ω

terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!

 Make sure that all units are connected to the mains.

 Each unit in the chain needs to have its proper starting address so it knows which

commands from the controller it has to decode. In the next section you will learn how

to set the DMX addresses.

BRITEQ

7/9

BEAMSPOT1-DMX NW (WW)

OPERATION MANUAL