KitchenAid KDTE104ESS3 Ficha técnica

Procurar online ou descarregar pdf Ficha técnica para Máquina de lavar loiça KitchenAid KDTE104ESS3. KitchenAid KDTE104ESS3 12 páginas.

Imprimir página

FOR SERVICE TECHNICIAN'S USE ONLY

W10880570A

DANGER

Electrical Shock Hazard

Only authorized technicians should perform diagnostic

voltage measurements.

After performing voltage measurements, disconnect

power before servicing.

Failure to follow these instructions can result in death

or electrical shock.

When performing live voltage measurements, you must do the following:

Verify the controls are in the off position so that the appliance does not start when energized.

■

Allow enough space to perform the voltage measurements without obstructions.

■

Keep other people a safe distance away from the appliance to prevent potential injury.

■

Always use the proper testing equipment.

■

After voltage measurements, always disconnect power before servicing.

■

Electrical Supply:

(Under load) 60 Hz, 120 VAC

Supply Water Flow Rate:

To fill 2 qt (1.9 L) in 27 seconds, 120 psi maximum, 20 psi minimum.

Supply Water Temperature:

120°F (49°C) (Before starting a cycle, run water from sink faucet until hot.)

Water Charge:

0.9 gal. (3.5 L) Approximate

Fuse Service Check:

F8 = Motor Fuse

F9 = Small-triac Load Fuse

Check operation of loads during the Service Diagnostics cycle.

If any of the triac loads work, F9 Fuse is OK.

■

If all triac loads fail to work, F9 Fuse could be open. See "Fuse

■

Resistance Check."

If Wash Motor does not work, F8 Fuse could be open. See "Fuse

■

Resistance Check."

NOTE: This sheet contains important Technical Service Data.

Voltage Measurement Safety Information

Pin 1

Rast Connector Pinout

Pin 1

Meter Check of Loads and Fuses

Tech Sheet

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

SPECIFICATIONS

Lower Spray Arm Rotation:

12 to 40 rpm

Upper Spray Arm Rotation:

12 to 30 rpm

REPAIR KITS

Vinyl Touch-up Kits:

675576 (Blue), 676453 (White), 676455 (Gray)

Control Assembly

Control

Assembly

Pinch to

release

Rotate

Connector Box

Connector Brace

(To remove, pinch

arms and rotate)

Fuse Resistance Check:

Unplug the dishwasher or disconnect power.

Measure resistance of F8 Fuse and/or F9 Fuse.

NOTE: Fuses are on the bottom of the Control Board but can be checked

from the top side. See "Control Pinout" diagram.

If resistance is <3 ?) then fuse is OK.

■

If resistance is >3 ?) then fuse is open.

■

What To Do If Fuse Open:

Inspect and check resistance of all loads on fuse. If any loads are open,

shorted, or have evidence of overheating or pinched wires, replace them.

Do Not Remove Or Destroy

WARNING

Electrical Shock Hazard

Control panel snap

locks control in place

Buttons on bottom

of control housing

slide into keyhole

slots on control

panel to support

the control