Ganz Thermal ZNT6-H Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Câmara IP Ganz Thermal ZNT6-H. Ganz Thermal ZNT6-H 11 páginas. Fixed camera

Fixed Camera Quick Start Guide

Fixed Mount 320x240 & 640x480 Pin-Out

Pins 1-3: Power (GND, 24V AC, 12-24 DC/24V AC)

Pins 3-4: RS-485 (POS, NEG)

AC/DC Power for Fixed Mount: Connect wires to power

block according the pin-out shown below:

If powering the camera with an AC supply, connect

AC+ to the 24VAC input and the AC- to the other

24VAC input

ii.

If powering the camera with a DC supply, connect the

DC+ to the 12VDC input and the DC- (or ground) to

the GND input.

12. Reconnect Power to the existing cable(s)

13. Check for Solid LED on the Ethernet connector to acknowledge

connectivity to the IP network. The status LED indicators are:

14. Place the supplied white desiccant into the Back Cover

15. Assemble the Back Cover. If captive screws are provided in the

Back Cover, secure to the IP camera with a Phillips #2

screwdriver. Otherwise, secure Back Cover to the IP Camera using

two #6 screws and two Master Seal Washers (metal side against

the head of the screw and gasket side against the camera body).

Tighten the 2 fasteners to approximately 10 in-lbs. of torque

16. Assemble the 2 Rubber Stem Bumpers onto the 2 detents in the

concave surface of the Solar Shroud

17. Snap the Solar Shroud, to the Base Mount

www.ganzsecurity.com

November 2014

Fixed Mount Pin-Out

RS-485: Connect wires to power block according to the

pin-out sown on the left (Fixed Mount 320x240 &

640x480 only)

LED 1: Solid Green for 10MB connection or Flashing

Green for Activity

LED 2: Solid Amber for 100MB connection.