Ganz Thermal PT Thermal Series Manual de início rápido

Procurar online ou descarregar pdf Manual de início rápido para Câmaras térmicas Ganz Thermal PT Thermal Series. Ganz Thermal PT Thermal Series 9 páginas.

Imprimir página
PT Thermal Series Quick Start Guide
Document Number: 1018264, Revision A
Important Safety Instructions
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Install in accordance with the manufacturer's instructions.
6.
Do not defeat the purpose of the polarized or grounding-type plug.
A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong is provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
7.
Use only with the tripod or bracket specified by the manufacturer, or
sold with the apparatus.
8.
Installation of the equipment must comply with local and national
electrical codes.
9.
This product must be connected to a Power Over Ethernet IEEE
802.af compliant power source or a UL Listed "Class 2" power supply
rated 12-24 V DC or 24 V AC minimum 13 W or 0.54 A.
10. Operating the camera at voltage levels outside the specified range
may result in permanent damage to the unit and void the product
warranty.
11. Clean the camera lens only with Kodak lens cleaning paper.
12. Failure to follow the proper procedure may cause permanent
damage to the camera and void the product warranty.
©Copyright 2013, CBC AMERICA, Corp. - All rights reserved. The contents of this document may not be reproduced in whole or in part without the written
DEVICE SENSITIVE TO ELECTROSTATIC DISCHARGE
The camera electronics and electronic interfaces are sensitive to
electrostatic discharge. Please follow appropriate ESD procedures when
handling the camera and during installation.
AMERICA strongly recommends the use of STP cabling and an earth
grounded end point to ensure proper ESD immunity.
powered installations, a properly earth grounded power source is strongly
recommended.
To ensure a proper earth ground (between the GANZ THERMAL camera
and a PoE switch) CBC AMERICA strongly recommends the use of Shielded
Twisted Pair (STP) cabling. Installations of GANZ THERMAL cameras using
a STP cabling and a properly earth grounded PoE switch are tested to
comply with industry immunity standards for Electro Static Discharge.
Any other installation method may leave the camera at risk and void the
warranty.
consent of the copyright owner.
December 2013
WARNING
For PoE installations, CBC
CAUTION
For AC or DC