decorflame QC211-GRDB Manual de instruções - Página 3
Procurar online ou descarregar pdf Manual de instruções para Fogão decorflame QC211-GRDB. decorflame QC211-GRDB 6 páginas.
Imprimir páginaS a F E t Y i N S t r U c t i O N S / O P E r a t i O N
12) a heater has hot and arcing or sparking
parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are
used or stored.
13) Use this heater only as described in this
manual. any other use not recommended
by the manufacturer may cause fire,
electric shock or injury to persons.
14) always plug heater directly into wall outlet
or receptacle. Never use with an extension
cord or retractable power bar (outlet/
power strip).
15) Do not plug this product into a receptacle
controlled by a wall switch or dimmer.
16) When storing or transporting the unit and
cord, keep in a dry place, free from
excessive vibration and store so as to
avoid damage.
SaVE tHESE iNStrUctiONS
FOr FUtUrE USE.
lEG aSSEMBlY
Before using your unit please install the legs
as shown in diagram below.
after completely reading instructions,
confirm that all controls on stove are in the
OFF position. Plug the unit into a 15 amp,
120 volt outlet.
a 15 aMP circuit is required to operate this
heater. if the breaker trips when the heater is
used then you may need to move the heater
to another location or unplug other appliances
that are on the same circuit. if you require
an extension cord, use one that is rated at
1875 watts.
OPEratiON
controls and switch are located on front panel
inside the glass door.
0/i: Press this button into "i" position for main
power and flame effect. the indicator light will
turn on.
HEatiNG: For heat function, press this
switch while the 0/i switch is in the "i"
position for heat. the indicator light will
turn on.
tHErMOStat: to adjust the temperature
to your individual requirements, turn the
thermostat dial to the right (clockwise)
to increase the temperature and to the
left (counter-clockwise) to decrease the
temperature. this thermostat control
dial can only be used while the "0/i"
switch and heating switches are in the "i"
position. When heater reaches the desired
temperature, the heater and heating
indicator light will turn OFF, but the fan
will continue to operate. adjust this knob
to restart the heater.
Note: When the "0/i" switch is turned to the
OFF position, all other heater functions will
stop even though the other switches may be in
the "i" position.
3