IKEA IUD9500WX2 Manual de instruções de instalação - Página 4
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça IKEA IUD9500WX2. IKEA IUD9500WX2 44 páginas. Undercounter dishwasher plastic giant tub models
Também para IKEA IUD9500WX2: Instruções para o utilizador (25 páginas)
Imprimir página
Product Dimensions
Side View
I_----
21 " (53.3
cm) -_
A. _" (1.9 cm) insulation by be compressed
(not used on all models)
B. 33 _" (86 cm) minimum
with wheels
removed
Rear View
237/8 '' (60.6 cm)
Installation Clearances
Cutout dimensions
(5.1 cm)
(25.4
cm
24"
(61
cm)*
34"
(86.4
cm)*
(5.1 cm)
l
6" (15.2
cm)***
(8.3 cm)
(7 cm) _
--
Cut holes in shaded area of cabinet walls or floor as specified below:
Water line - ½" (1.3 cm)
Drain line - 1 ½" (3.8 cm)
Direct wire - _" (1.9 cm)
Power supply cord - 1 ½" (3.8 cm)
*Measured from the lowest point on the underside of the
countertop.
May be reduced to 337/8 '' (86 cm) by removing the
wheels from the dishwasher.
**Minimum, measured from narrowest point of opening.
***May be increased to 68/8 '' (16.6 cm) if height of opening is 341/2 ''
(87.6 cm) at its lowest point.
Use the new drain hose supplied with your dishwasher. If this
is not long enough, use a new drain hose with maximum
length of 12 ft (3.7 m) that meets all current AHAM/IAPMO
test
standards, is resistant to heat and detergent, and fits the
1" (2.5 cm) drain connector of the dishwasher.
Connect drain hose to waste tee or disposer inlet above drain
trap in house plumbing and 20" (50.8 cm) minimum above the
floor. It is recommended
that the drain hose either be looped
up and securely fastened to the underside of the counter, or
be connected to an air gap.
Use a drain air gap if the drain hose is connected to house
plumbing lower than 20" (50.8 cm) above the subfloor or floor.
Use 1/2"(1.3 cm) minimum I.D. drain line fittings.