IKEA IUD9750WS4 Manual de instruções de instalação - Página 15
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça IKEA IUD9750WS4. IKEA IUD9750WS4 48 páginas. Undercounter dishwasher
Também para IKEA IUD9750WS4: Instruções para o utilizador (25 páginas)
Imprimir página
IMPORTANT: You need to know which control panel is on your
dishwasher before your order your custom door panel.
= ;
hw;i=1
with control panel on the top
231/2 '' _
(59.7 cm)
I
"303A6" (76.7 cm)
3/4" (19.1 mm)
*This
dimension
is for 4" (10.2 cm) toe kick. If the
installation
needs a higher toe kick, adjust the height
of the wood panel accordingly.
Not recommended
for
. toe kicks greater than 6" (15.2cm).
.
J
with control panel on the front
_9.1
mm)
(3.2 mm)
(3.2 mm]
*This
dimension
is for 4" (10.2 cm) toe kick. If the
installation
needs a higher toe kick, adjust the height
of the wood panel accordingly.
Not recommended
for
toe kicks greater than 6" (15.2 cm).
NOTE: The handle for the custom panel is not included.
IMPORTANT: If the handle is attached from the back of the
custom panel, the screw holes should be countersunk
for the
screws heads to be flush with the panel. If the handle is attached
to the front of the custom panel, the screw lengths cannot exceed
the panel thickness.
NOTES:
A customer-supplied
full front panel must weigh no more than
16 Ibs (7.3 kg) and must be made to specific dimensions. It is
recommended
that a cabinetmaker
cut the custom panel
because of the precise dimensions needed.
All mounting hardware supplied is for a 3/4"(19.1 mm) thick
wood panel. If a thinner wood panel, or materials other than
wood are used, it is the consumer's responsibility to obtain the
proper length screws and adjust the pilot holes accordingly.
IMPORTANT: Use a moisture-resistant
sealer on both sides and
all edges of the panel to avoid damage from humidity.
1]Custom
panel installatio
}_ii
--:J Dishwashers
with control/iiii
panel on the top
3/4"(19.1 mm)
*This dimension
is for 4" (10.2 cm) toe kick. If the
installation
needs a higher toe kick, adjust the height
of the wood panel accordingly.
Not recommended
for
toe kicks greater than 6" (15.2 cm).
With a TORX _)tscrewdriver, remove three screws from both sides,
as shown; hold the outer panel up while removing the screws.
Save screws for reinstallation.
1-®TORX is a registered trademark
of Saturn Fasteners, Inc.
15