ENGLISH
German degrees
(°dH)
<4
1) Factory setting.
2) Do not use salt at this level.
How to set the water softener level
The appliance must be in programme
selection mode:
1. To enter the user mode, press and hold
simultaneously
indicators
,
2. Press
.
• The indicators
• The indicator
• The indicator
number of flashes indicates the level.
– E.g. 5 flashes + pause + 5 flashes
= level 5.
3. Press
repeatedly to change the
setting. Each time you press
number increases. After level 10 you will
start again from level by 1.
4. Press the on/off button to confirm the
setting.
Acoustic signals
The acoustic signals operate when the
appliance has a malfunction and it is not
possible to deactivate them.
Before first use
1. Make sure that the current level of the
water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
French degrees
(°fH)
<7
and
until the
and
start to flash.
and
go off.
continues to flash.
starts to flash. The
the level
mmol/l
Clarke de-
grees
<0.7
There is also an acoustic signal that
operates when the programme is
completed. By default, this acoustic signal is
on, but it is possible to deactivate it.
How to deactivate the acoustic signal for
the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and hold
simultaneously
indicators
2. Press
.
• The indicators
• The indicator
• The end indicator indicates the
current setting: End indicator on=
Acoustic signal on.
3. Press
to change the setting.
• End indicator off = Acoustic signal
off.
4. Press the on/off button to confirm the
setting.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
Water softener level
< 5
1
and
until the
,
and
start to flash.
and
continues to flash.
10
2)
go off.
Imprimir página