IKEA UNDERCOUNTER DISHWASHER PLASTIC GIANT TUB MODELS Manual de instruções de instalação - Página 8
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça IKEA UNDERCOUNTER DISHWASHER PLASTIC GIANT TUB MODELS. IKEA UNDERCOUNTER DISHWASHER PLASTIC GIANT TUB MODELS 44 páginas.
Imprimir página
Prepare Cabinet Opening Where There
Are No Existing Utility Hookups
Electrical Connection
Option 1: Direct Wire Method
Helpful Tip: Wiring the dishwasher will be easier if you route wire
into the cabinet opening from the right-hand side.
1. Drill a ³⁄₄" (1.9 cm) hole in right-hand cabinet side, rear or floor.
Preferred and optional locations are shown.
A. Optional locations
B. Preferred locations
2. Wood cabinet: Sand hole until smooth.
Metal cabinet: Cover hole with grommet, not provided.
3. Run wire into house wiring junction box.
4. Install a UL-listed/CSA-certified clamp connector (strain relief)
for flexible-type wire. If installing conduit, attach a UL-listed/
CSA-certified conduit connector to the junction box.
5. Run other end of wire through cabinet hole. Cable must
extend to the right front of cabinet opening.
A. Direct wire
Option 2: Power Supply Cord Method
NOTE: A mating, three-prong, grounded-type wall receptacle is
required in a cabinet next to the dishwasher opening.
1. Drill a 1¹⁄₂" (3.8 cm) hole in the cabinet rear or side. Preferred
and optional locations are shown.
A. Optional locations
B. Preferred locations
2. Wood cabinet: Sand hole until smooth.
Metal cabinet: Cover hole with grommet
(Part Number 302797) included with power supply cord kit.
8
A
B
A
A
B
Install the Water Line
Helpful Tip: Routing the water line through the left side of cabinet
opening will make water connection easier.
1. Drill a minimum ¹⁄₂" (1.3 cm) hole in the cabinet side, rear or
floor. Preferred and optional locations are shown.
A. Optional locations
B. Preferred locations
2. Measure overall length of copper tubing required.
3. Attach copper tubing to the water line with a manual shutoff
valve.
A
A. Copper tubing
4. Slowly feed copper tubing through hole in cabinet. Copper
tubing will bend and kink easily, so be gentle. The copper
tubing should be far enough into the cabinet opening to
connect it to dishwasher inlet on the front left of the
dishwasher.
5. Turn water shutoff valve to "ON" position. Flush water into a
shallow pan to get rid of particles that may clog the inlet valve.
6. Turn shutoff valve to "OFF" position.
Install the Drain Hose
IMPORTANT: Always use a new drain hose even when installing a
new replacement dishwasher.
1. Drill a 1¹⁄₂" (3.8 cm) diameter hole in the cabinet wall or floor on
the side of the opening closest to the sink.
2. Connect drain hose to waste tee or waste disposer using one
of the following methods:
■
Option 1, Waste disposer – with air gap
■
Option 2, No waste disposer – with air gap
■
Option 3, Waste disposer – no air gap*
A
B