Avantco 178AU27FHC Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Congelador Avantco 178AU27FHC. Avantco 178AU27FHC 10 páginas. Commercial refrigerators and freezers
Também para Avantco 178AU27FHC: Manual do utilizador (9 páginas)

Imprimir página

User Manual

Installation

Please read this manual thoroughly prior to equipment set-up, operation, and maintenance.

This unit is intended for use in a temperature-controlled environment less than 75 degrees Fahrenheit

and 60% relative humidity. Malfunction due to improper conditions is not covered under warranty.

IMPORTANT!!! PLEASE READ BEFORE INSTALLATION:

• If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to

promote proper air flow. Failure to install the shelves properly is considered user error and is not

covered by warranty.

• If the unit has recently been transported on its side, please let unit stand still for a minimum of 24

hours before plugging it in.

• Make sure that the unit has reached the desired temperature before loading the unit with products.

This unit is meant for keeping cold products cold, not chilling warm products.

• Make sure that there is proper ventilation around the unit in the area where it will operate.

• Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging the unit

in.

• Do not attempt to remove or repair any component of the unit. Consult an authorized service

technician for servicing / repair.

• Do not sit / stand inside the unit.

• Please read through the manual in its entirety.

• This unit is designed to perform in a temperature-controlled environment at 60% relative humidity.

The unit should be located away from doors, air ducts, and fans that could disrupt airflow and

negatively impact performance.

Cabinet Location Guidelines

• Install the unit on strong and leveled surfaces.

a. If the surface is uneven, the unit may be noisy.

b. The unit may malfunction if the surface is uneven.

• Install the unit in an indoor, well-ventilated area.

a. For best performance, please maintain clearance of 4" on the back of the unit.

b. Brackets should be attached on the back of the unit.

c. Do not use outdoors. For indoor use only.

d. Avoid direct sunlight.

• Avoid installation in a high humidity and / or dusty area.

a. Humidity above 60% can cause the unit to rust, collect condensation, and decrease

efficiency.

b. Dust collected on condenser coil will cause unit to malfunction.

c. Malfunction due to temperatures above 75 degrees Fahrenheit, humidity above 60%, or

improperly maintained condenser coil will void the warranty.