Makita 1806B Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 1806B. Makita 1806B 13 páginas. Power planer
Também para Makita 1806B: Manual de instruções (17 páginas), Repartição das peças (3 páginas), Manual de instruções (10 páginas), Manual de instruções (13 páginas), Manual de instruções (11 páginas)

Makita 1806B Manual de instruções
ASSEMBLY
1
2
1. Hex wrench
2. Bolt
1. Adjusting screw
2. Planer blade
3. Notch in the blade
4. Drum cover
5. Drum
1
1. Triangular rule
2. Screwdriver
6
CAUTION:
Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Removing or installing planer blades
002560
CAUTION:
Tighten the blade installation bolts carefully when attaching the blades to
the tool. A loose installation bolt can be dangerous. Always check to see
they are tightened securely.
Handle the blades very carefully. Use gloves or rags to protect your
fingers or hands when removing or installing the blades.
Use only the Makita wrench provided to remove or install the blades.
Failure to do so may result in overtightening or insufficient tightening of
the installation bolts. This could cause an injury.
To remove the blades on the drum, unscrew the five installation bolts with the
hex wrench. The drum cover comes off together with the blades.
To install the blades, first clean out all chips or foreign matter adhering to the
002561
drum or blades. Use blades of the same dimensions and weight, or drum oscil-
1
lation/vibration will result, causing poor planing action and, eventually, tool
breakdown.
2
There are two adjusting screws for each blade. When installing the blade, the
3
notch in the blade should fit over the head of the adjusting screw. Then fit on
the drum cover and secure all the installation bolts only finger-tight.
4
Turn the drum until the blade edge is right in the middle between the front and
rear bases.
5
Place the triangular rule flat on the rear base and run it out over and across the
002562
blade edge. Turn the two adjusting screws to adjust the blade protrusion. The
blade setting should be made so that the protrusion will be uniform all the way
2
across. Thus the triangular rule should be flush with the entire width of the
blade edge. After adjusting both blades, tighten all the installation bolts evenly
and alternately with the wrench.
After tightening the bolts, secure the adjusting screws fully.
For the correct planer blade setting
Your planing surface will end up rough and uneven, unless the blade is set
properly and securely. The blade must be mounted so that the cutting edge is
absolutely level, that is, parallel to the surface of the rear base.
Refer to some examples below for proper and improper settings.