Avantco 178GDW49BB Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Merchandiser Avantco 178GDW49BB. Avantco 178GDW49BB 9 páginas. Wine merchandiser refrigerators

Imprimir página

Troubleshooting

Problem

Possible Cause

Fuse blown or circuit breaker tripped.

Power cord unplugged.

Compressor

not running.

Thermostat set too high.

Cabinet in defrost cycle.

Excessive amount of water product in

cabinet.

Prolonged door opening or door ajar.

Dirty condenser coil.

Condensing units run

for long periods of time.

Evaporator coil iced over.

Door gasket not sealing properly.

Thermostat set too warm.

Airflow blocked.

Excessive amount of warm product placed

in cabinet.

Cabinet temperature

Fuse blown or circuit breaker tripped.

is too warm.

Dirty condenser coil.

Evaporator coil iced over.

Low refrigerant levels.

Door is slightly ajar.

Poor switch connection.

Interior light is

Bulb is not connected.

not working.

Bulb has burned out.

Condensation is

collecting on the

Relative humidity is above 60%.

cabinet and/or floor.

User Manual

Wine Merchandiser Refrigerators

Possible Solution

Replace fuse or reset circuit breaker.

Plug in power cord.

Set thermostat to lower temperature.

Wait for defrost cycle to finish.

Allow adequate time for product to cool down.

Ensure doors are closed when not in use. Avoid

opening the doors for long periods of time.

Clean the condenser coil.

Unplug unit and allow coil to defrost. Make sure

thermostat is not set too cold. Ensure that door

gasket(s) are sealing properly.

Ensure gaskets are snapped in completely.

Remove gasket and wash with soap and water.

Check condition of gasket and replace if

necessary.

Set thermostat to lower temperature.

Re-arrange product to allow for proper airflow.

Make sure there is at least 4" of clearance from

evaporator.

Allow adequate time for product to cool down.

Replace fuse or reset circuit breaker.

Clean the condenser coil.

Ensure doors are closed when not in use.

Avoid opening doors for long periods of time.

Contact a service technician to check

refrigerant levels.

Make sure door is completely closed.

Turn off light switch and turn it back on.

Make sure the bulb is correctly inserted in

the socket.

Replace the bulb.

Move unit to area below relative humidity or

lower humidity level.