Makita 3620 Manual de instruções - Página 7
Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 3620. Makita 3620 20 páginas. Router
Também para Makita 3620: Manual de instruções (13 páginas), Manual de instruções (17 páginas), Manual de instruções (17 páginas), Manual de instruções (18 páginas)
Imprimir página
Adjusting lock lever
The locked position of the lock lever
is
adjustable. To adjust
it,
loosen the lock
lever 3/4 turn and press the center of the
lock lever. The hex nut will come out. Set
the hex nut to the desired position and
tighen the lock lever.
Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop.
CAUTION:
Before plugging in the tool, always check
to see that the trigger switch actuates pro-
perly and returns to the "OFF" position
when released.
Operation
*Set the tool base on the workpiece to be cut without the bit making any contact. Then
turn the tool on and wait until the bit attains full speed. Lower the tool body and move
the tool forward over the workpiece surface, keeping the tool base flush and advancing
smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should be on the left side of the bit in
the feed direction. (See the figure below)
Feed direction
r _ _ - ,
~..
///,'/!3it
revolving direction
7 ,
(View from the top of the tool)
v
Correct bit feed direction
NOTE
:
Moving the tool forward too fast may cause a poor quality of cut, or damage to the bit
or motor. Moving the tool forward too slowly may burn and mar the cut. The proper
feed rate will depend on the bit size, the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is advisable to make a sample cut
on
a
piece of scrap lumber. This will show exactly how the cut will
look as
well
as
enable you
to check dimensions.
*When using the straight guide, be sure to install it on the right side in the feed direction.
This will help to keep
it
flush with the side of the workpiece.
7