Garage Tek GT1006 Manual de instalação e do proprietário - Página 6

Procurar online ou descarregar pdf Manual de instalação e do proprietário para Racks & Stands Garage Tek GT1006. Garage Tek GT1006 6 páginas. Tall cabinet

Imprimir página
STEP 8B
W
V
T
STEP 8: INSTALL CABINET BRACKET IN TEKPANEL AND MOUNT CABINET
A.
PLACE THE CRADLE (T), QTY 1, IN THE 7TH SLOT ABOVE THE BASE MOLDING TOP AND PLACE THE CABINET IN THE
CRADLE.
B.
ASSEMBLE THE SPEED NUTS (W), QTY 2, THE SCREWS (V), QTY 2, TO THE "LGSLT BRACKET" (U) QTY 2. PLACE THESE
BRACKETS IN THE PANEL SLOTS APPROXIMATELY 6" FROM THE TOP OF THE CABINET AND 6" FROM THE SIDES.
C.
PRESS THE CABINET BACK TO TOUCH THE SCREW ENDS AND FIRMLY PUSH UNTIL A WHITE MARK APPEARS WHERE
EACH SCREW TOUCHES. USE A 3/4" TO 1" INCH DRILL BIT AND DRILL THROUGH THE CABINET BACK. INSTALL THE
WASHERS (Y), QTY 2, AND WING NUTS (X), QTY 2, AS HOWN.
UNDER LOAD, THE CABINET WILL SETTLE SLIGHTLY AND IF A SMALLER DRILL BIT THAN 3/4" DIA. IS USED, THE CABINET
WILL PULL DOWN FROM THE SCREWS IN THE "LGSLT BRACKET". THIS WILL EVENTUALLY CAUSE THE CABINET SECTIONS
TO SEPARATE. SEE THE DIAGRAM BELOW.
IMPORTANT: THE TOP CABINET CONNECTION WITH THE "LGSLT BRACKET" IS INTENDED AS A SAFETY FEATURE TO
PREVENT IT FROM TIPPING FORWARD. THESE BRACKETS ARE NOT INTENDED TO CARRY THE LOAD. THE BOTTOM
CRADLE CARRIES THE LOAD.
U
V
Y
X
NO GOOD
BACK OF
CABINET
SMALL
HOLE
3/4" TO 1"
HOLE
CORRECT
PAGE 6 OF 6 REV SEPT 2021