Makita 4328 Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 4328. Makita 4328 13 páginas. Jig saw
Também para Makita 4328: Manual de instruções (13 páginas), Especificações (2 páginas), Informações técnicas (7 páginas), Manual de instruções (13 páginas), Manual de instruções (13 páginas)

Makita 4328 Manual de instruções
(3)
As the blade pierces the workpiece, slowly
lower the base of the tool down onto the
workpiece surface.
(4)
Complete the cut in the normal manner.
Finishing edges
008094
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.

Dust extraction

1
008095
Clean
cutting
operations
connecting this tool to a Makita vacuum cleaner. Insert
the hose of the vacuum cleaner into the hole at the rear
of the tool. Lower the dust cover before operation.
NOTE:
Dust extraction cannot be performed when making
bevel cuts.
Rip fence (optional accessory)
CAUTION:
Always be sure that the tool is switched off and
unplugged
before
accessories.
1. Dust cover
2. Hose
2
can
be
performed
installing
or
removing
1.
Straight cuts
Steel base type
008096
When repeatedly cutting widths of 160 mm or less,
use of the rip fence will assure fast, clean, straight
cuts.
Alminum base type
008097
To install, insert the rip fence into the rectangular
hole on the side of the base with the fence guide
facing down. Slide the rip fence to the desired
cutting width position, then tighten the bolt to
secure it.
by
2
3
002776
Aluminum base type
1
2
005454
8
1. Rip fence
(Guide rule)
1
1. Rip fence
(Guide rule)
1
1. Hex wrench
Steel base type
2. Bolt
3. Rip fence
1
(Guide rule)
4. Guide facing
4
1. Bolt
2. Fence guide
3. Hex wrench
4. Rip fence
(Guide rule)
3
4