Avantco Equipment 449SF3 Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Equipamento comercial para alimentos Avantco Equipment 449SF3. Avantco Equipment 449SF3 9 páginas. Blast chiller/freezer
Imprimir páginaOther Controls
To change between C and F
View the set temp and time
Electrical
• Please ensure that the required voltage is being supplied at all times.
• The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate
over-current protection. Please refer to the electrical requirements on the unit's nameplate.
• The unit should have its own dedicated outlet.
• Do not use extension cords.
• Ensure the unit is not resting on or against the electrical cord.
• If the unit is not in use for a long period of time, please unplug the unit from the outlet.
• To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.
• After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could
cause damage to the compressor.
Defrost System
Refrigeration units contain an automatic defrost system. Refrigeration coils are kept below the
freezing point (32 degrees fahrenheit). During compressor downtime, the evaporator fan continues
to circulate air through the evaporator coil. This air circulation raises the coil temperature above the
freezing point, melting any accumulated frost. Run-off water is drained into the evaporator pan and
evaporated.
Use
High liquid content foods should be limited to 50% capacity of the machine's total cooling capacity.
To avoid surpassing the internal pressure limit of the compressor, and extend the life of the
compressor, allow the unit 2 minutes in between cycles. After 2 minutes, press start/stop button, the
compressor will start, and after another 2 minutes the evaporator fan starts.
In the quick freeze modes, if the start/stop button in pressed, and the temperature of the cabinet is
less than the set temperature, the compressor will not start until the temperature is greater than or
equal to the set point.
User Manual
Description
Can be switched by pressing and holding the SET and '-' button for 3 seconds.
Press and hold the SET button to view set temperature and set time.
- 5 -