Garage1217 project ember Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Amplificador Garage1217 project ember. Garage1217 project ember 15 páginas.

Project

Ember

STEP 1: POPULATE ALL SMALL COMPONENTS ON THE BOARD SUCH AS RESISTORS, RIGHT ANGLE JUMPERS,

DIODES AND SMALL CAPACITORS. THROUGHOUT YOUR BUILD, ALWAYS INSTALL THE SMALLER PARTS FIRST,

WORKING YOUR WAY UP TO THE LARGER COMPONENTS

NOTCH ON THE RGB LED

(ORIENTATION MARKING)

MUST FACE THE WHITE

MARKING ON THE PCB AS

SHOWN

LED MUST BE INSTALLED

BEFORE SOLDERING THE

TUBE SOCKET IN PLACE

- RESISTORS AND INDUCTORS ARE NONPOLAR AND CAN BE FITTED IN EITHER DIRECTION. WHEN INSTALLING COMPONENTS,

MAKE SURE THE COMPONENT VALUES ALWAYS FACE UP SO THEY ARE VISIBLE (CAN AID IN TROUBLESHOOTING IF A

COMPONENT IS PLACED IMPROPERLY)

- DIODES, TRANSISTORS, IC'S AND ELECTROLYTIC CAPACITORS ARE POLAR AND PROPER ORIENTATION IS REQUIRED

PAY CLOSE ATTENTION TO

THE BLACK BAND ON ALL

DIODES OR ZENERS AS THEY

ARE DIRECTIONAL

PAY CLOSE ATTENTION

TO THE GRAY BAND ON

EACH DIODE AS THEY ARE

DIRECTIONAL

FLAT SPOT OR THE

SHORT LEAD ON RED LED

(INDICATES NEGATIVE

SIDE OF LED) MUST FACE

EXACTLY AS SHOWN