Garage1217 Project Solstice Manual do utilizador - Página 13
Procurar online ou descarregar pdf Manual do utilizador para Amplificador Garage1217 Project Solstice. Garage1217 Project Solstice 14 páginas.
Imprimir páginaProject
Solstice
Project Solstice has several jumpers settings to customize the amp the way you would like it. Below gives you the
details on what these jumper settings do!
THE 6V / 12V JUMPER ALLOWS YOU TO USE BOTH 6 AND 12 VOLT MINIATURE 9 PIN DUAL
TRIODE TUBES. BEFORE POWERING ON YOUR AMPLIFIER, YOU MUST MAKE SURE WHAT
VOLTAGE YOUR TUBE RUNS AT AND SET IT ACCORDINGLY VIA THE JUMPER. ATTACH THE
JUMPER TAB TO THE CENTER PIN AND TO THE SIDE PIN CLOSEST TO THE VOLTAGE YOU
DESIRE (6v OR THE 12v
TO NOTE: IF IN DOUBT, SET THE AMP TO 12V. IF ONLY ONE CHANNEL WORKS, CHANGE IT TO
THE 6V SETTING. THIS JUMPER CANNOT DAMAGE A TUBE IF SET TO THE WRONG VOLTAGE
CALLING OUT A GOOFUP I MADE ON THE SILKSCREEN.
SETTINGS FOR OUTPUT RESISTANCE ARE REVERSED. LOW IS
SIDE)(EXAMPLE OF 6V SETTING IN RED)
OUTPUT RESISTANCE IS CONFIGURABLE BETWEEN 0.1Ω (H)
31Ω (M) AND 68Ω (L). HIGHER OUTPUT
RESISTANCE CAN HAVE AN EFFECT ON BASS AND/OR TREBLE
FREQUENCIES. THIS EFFECT IS DEPENDANT ON THE HEADPHONE
IMPEDANCE. (EXAMPLE OF .1Ω SETTING IN RED) EXPERIMENT BY
CHANGING THE SETTINGS TO FIND WHAT YOUR PREFERENCE IS.
THERE IS NO RIGHT OR WRONG SETTING
ACTUALLY
CAUTION!!! READ INSTRUCTIONS CAREFULLY!!!
THE OHV "OPTIONAL HEATER VOLTAGE" JUMPER IS
SPECIFICALLY INSTALLED FOR THOSE WHO ARE
RUNNING 8 PIN OCTAL BASED 12SN7 TUBES
IF THIS JUMPER IS ACCIDENTALLY CHANGED WITH THE
WRONG TUBE INSTALLED OR CHANGED WITH THE
AMPLIFIER TURNED ON - TUBE DAMAGE OR TUBE
FAILURE WILL OCCURE. IN SHORT DO NOT TOUCH THIS
JUMPER UNLESS YOU KNOW WHAT YOU ARE DOING
1. WHEN USING THE OHV FEATURE, MAKE SURE TO TURN
THE AMPLIFIER OFF
2. CHANGE THE OHV JUMPER FROM DFLT TO OHV
3. CHANGE THE 6V / 12V JUMPER TO 12V
4. INSTALL A G1217 8 TO 9 PIN ADAPTER WITH 12SN7
SERIES TUBE
5. DOUBLE CHECK THE TUBE YOU ARE USING IS IN THE
12SN7 FAMILY AND THAT THE TUBE IS RATED AT 12V
6. TURN THE AMPLIFIER ON AND ENJOY!
7 IF GOING BACK TO A 9 PIN MINIATURE TUBE, TURN THE
AMPLIFIER OFF AND CHANGE THE OHV JUMPER BACK TO
DFLT AND DOUBLECHECK YOUR SETTING
THE UNDER
TUBE LED CAN
BE TURNED ON
OR OFF VIA
THIS JUMPER
H
AND
H
IS ACTUALLY
L | M | H
L