GarageAce R5 Manual de instruções de instalação - Página 10
Procurar online ou descarregar pdf Manual de instruções de instalação para Abertura de porta de garagem GarageAce R5. GarageAce R5 20 páginas. Roller garage door opener
Imprimir página13. Installation Procedure
Do not allow people to walk under or around the door during the installation process as serious
injury can occur.
NOTE: The opener can be installed on either side of the door. The following instructions are for
RIGHT HAND INSTALLATIONS (as illustrated i.e. inside the garage looking out). For left hand
installations, reverse the instruction terminology (eg LEFT for RIGHT etc).
Preparation:
•
Place the opener in manual release mode (refer Section 9).
•
Open the roller door fully. For safety, tie a rope around the
door.
•
Ensure the door axle U-BOLT and door mounting bracket
on the left hand side (non opener side) are securely
fastened.
•
Support the door with a door stand or similar device to
safely support the door.
•
Mark the position of the door shaft on the right hand door
bracket (for reassembly purposes).
•
While the door is supported, remove the right hand axle U-
Bolt and door mounting bracket from the wall.
Install the opener:
•
Slide the opener over the door axle and engage the drive
legs into the door drum wheel, either side of a spoke.
Extensions may be necessary (refer Section 11).
•
Refit the door mounting bracket to the wall. If the door
bracket needs to be relocated due to opener width, refer
Section 4.
•
Clamp the opener on the door axle and door bracket in the
marked position using the clamp assembly supplied (tighten
to 25 – 28 Nm).
•
If side room exceeds 95mm clamp independently to the
door axle as illustrated in Section 4.
•
Remove all ropes and the support stand.
•
Check the operation of the door in manual mode by raising
and lowering by hand. It should operate smoothly without
sticking or binding. The disengage handle should already be
attached less than 1.8m above the floor (refer Section 5 and
Section 8).
10