ALIBI ALI-NS8024VR Manual de instalação rápida - Página 6
Procurar online ou descarregar pdf Manual de instalação rápida para Câmara de segurança ALIBI ALI-NS8024VR. ALIBI ALI-NS8024VR 8 páginas. 4 mp 4× zoom mini ptz ip camera
Imprimir página
For cameras installed on a LAN
1.
Log into the camera and then open the Live View window.
2.
Click the joystick icon to open the PTZ control panel. See above.
3.
In the PTZ control panel, click each button shown in the graphic below. Verify that the camera
performs as expected. Refer to the Specifications section of this document for motion and zoom
ranges.
Direction buttons
Continuous
pan
For cameras connected directly to an NVR
Refer to the firmware manual for your NVR for specific instructions to perform the following:
1.
Log into the NVR at the NVR console.
2.
In the Live View display, find the PTZ camera you installed. Click on the camera to open the
Quick Setting toolbar.
PTZ Control icon
3.
Click the PTZ Control icon. See above.
In the pop-up PTZ menu, click the PTZ Control tab. See below.
4.
PTZ Control tab
Direction buttons
Continuous
pan
6
www.observint.com
Open / Close PTZ Control Panel
PTZ Control Panel
Zoom In / Out
Focus In / Out
Iris Open / Close
Zoom In / Out
Focus In / Out
Iris Open / Close
5.
In the PTZ Control panel, click each button labeled in the graphic above. Verify that the camera
performs as expected. Refer to the Specifications section of this document for motion and zoom
ranges.
Step 8.
Adjust the camera image for your surveillance target
Use the firmware menus to adjust the brightness, contrast, saturation and sharpness of the video image
if necessary. These settings are initially optimized at the factory and may not need adjustment. When
adjustments are necessary, the paths to the image settings menus are different if the camera is installed
as a device on a LAN, or if it is connected to a NVR. Select the installation type below for your camera to
complete this step.
For cameras installed on a LAN
1.
If necessary, log into the camera on the LAN with administrative credentials.
2.
After adjusting the camera for the a typical field of view, click the Setup tab, and then click the
Image link in the left frame.
3.
Adjust the Brightness Contrast, Saturation and Sharpness of the image. Each parameter can be
set to a level of 0 ~ 100 either by moving the slider or entering the value in the box on the right.
The effect of the adjustment will appear in the Live View image in the menu.
Refer to the firmware user manual for your camera to use the other submenus on this screen.
For cameras connected directly to an NVR
1.
Log into the NVR with administrative privileges.
2.
Open the firmware Image menu. Go to Menu | Camera Management | Image
3.
In the Camera field drop down list, select the camera you want to configure. In the example
above, [D1]IPCamera 01 is selected.
4.
Drag the Brightness, Contrast, Saturation and Hue adjustment markers left or right to
perfect the image from the camera. For some adjustments, you can click the up ( 5 )or down
( 6 )icons near the adjustment value (on the right side) to incrementally change the value of
those adjustment.
Click Apply to save your settings for this camera.
5.
Refer to the firmware user manual for your NVR to use the other submenus on this screen.
© 2019 Observint Technologies. All rights reserved.