Makita 4351T Manual de instruções - Página 6
Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 4351T. Makita 4351T 13 páginas. Jig saw
Também para Makita 4351T: Especificações (2 páginas), Manual de instruções (13 páginas), Manual de instruções (9 páginas), Informações técnicas (15 páginas)
Imprimir página
To start the tool, slide the switch lever to the "I" position.
To stop the tool, slide the switch lever to the "O" position.
Speed adjusting dial
For 4351CT, 4351FCT
008032
The tool speed can be infinitely adjusted between 800
and 2,800 strokes per minute by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 5; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Workpiece to be cut
Wood
Mild steel
Stainless steel
Aluminum
Plastics
006368
CAUTION:
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
Soft start feature
Safety and soft start because of suppressed starting
shock.
Lighting up the lamps
For 4351FCT only
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
1. Speed adjusting
1
dial
Number on adjusting dial
4 - 5
3 - 5
3 - 4
3 - 5
1 - 4
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
Do not touch the blade or the workpiece
•
immediately
extremely hot and could burn your skin.
Tighten the saw blade securely. Failure to do so
•
may cause a serious injury.
When you remove the saw blade, be careful not to
•
hurt your fingers with the top of the blade or the
tips of workpiece.
To install the blade, open the tool opener to the position
shown in the figure.
1
008007
Keeping that situation, insert the saw blade into the
blade clamp as far as the two protrusions of the blade
can not be seen.
1
2
008008
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
6
after
operation;
they
1. Tool opener
1. Blade clamp
3
2. Jig saw blade
3. Protrusions
may
be