Makita 5093DZ Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 5093DZ. Makita 5093DZ 20 páginas. 85 mm (3-3/8”)

Charging

*Your new battery cartridge is not charged.

You will need to charge it before use. Use

the high capacity battery charger Model

DC1411 to charge the battery cartridge.

*Plug the high capacity battery charger into

the proper A.C. voltage source. The charg-

ing light will flash in green color.

*Insert the battery cartridge so that the plus

and minus terminals on the battery car-

tridge are on the same sides as their

respective markings on the high capacity

battery charger. Insert the cartridge fully into the port so that it rests on the charger port

floor.

*When the battery cartridge is inserted, the charging light color will change from green to

red and charging will begin. The charging light will remain lit steadily during charging.

*When the charging light color changes from red to green, the charging cycle is complete

and the charger will switch into its "trickle charge (maintenance charge)" mode. The

charging time is approximately one hour.

*After charging, unplug the charger from the power source

CAUTIO N :

*The high capacity battery charger Model DC1411 is for charging Makita battery cartridge.

Never use it for other purposes or for other manufacturer's batteries.

*When you charge a new battery cartridge or a battery cartridge which has not been used

for a long period of time,

may not accept a full charge. This is normal condition and

does not indicate a problem. You can recharge the battery cartridge fully after discharging

it completely and recharging a couple of times.

*If you charge a battery cartridge from a just-operated tool or a battery cartridge which has

been left in a location exposed to direct sunlight or heat for a long time, the charging light

may flash in red color. If this occurs,

wait

for a while. Charging will begin after the battery

cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge

from the high capacity battery charger.

*If the charging light flashes alternately in green and red color,

problem exists and charg-

ing is not possible. The terminals on the charger or battery cartridge are clogged with

dust or the battery cartridge is worn out or damaged.

*If you wish to charge two battery cartridge, allow 15 minutes between charging on the

High Capacity Battery Charger.