2M Technology 2MGST-6 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Controlador 2M Technology 2MGST-6. 2M Technology 2MGST-6 6 páginas. Turnstyle controller

Turnstile Controller User Manual

| 2M Technology

4. Audio Set

1. Entry Prompt – prompt when entering

2. Exit Prompt – prompt when exiting

3. Break In – prompt when there is unauthorized entry

4. Tail Warn – tailgating warning

5. Stay Warn – warning when a person is staying in the passageway for too long

5. Time Set

1. Wait Time Out: the amount of time that the gate will stay open after tapping your card. For example: The default

time is set to 5 seconds. If you tap your card, but no one goes through the passageway, after 5 seconds the gate will

close again.

2. Stay Alarm Time: if you stay in the passageway for the amount of time that is configured, then an alarm will sound.

3. Off Time: set the delay closing time. For example: if it is set to 5 seconds, then the gate will close after 5 seconds

after people pass through.

4. IR Check Dly: set the infrared sensitivity. The smaller the value, the more sensitive it will be. Note: please do not set

this without one of our technician's assistance. The default value has been set according to our recommendations.

5. Alarm Dly: Alarm time. For example: if it has been set to 5 seconds, the alarm will sound for 5 seconds.

6. Sys Info

1. Language

2. Reset Para – reset parameters

3. Version

4. Device Address

5. RS232 Speed – 115200, 38400, 19200, 9600, or 4800. The default is 115200. Only for factory use

6. RS485 Speed – 115200, 38400, 19200, 9600, or 4800. The default is 115200. Only for factory use

7. Servo port – RS232 or RS485. The default is RS232. Note: If this setting is changed, it can affect the operation of

the gate. Only for factory use

8. Control PROT – control protocol, RD001 or TB001. The default is RD001. Only for factory use