AVANTEK B06Y21NV8B Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Acessórios AVANTEK B06Y21NV8B. AVANTEK B06Y21NV8B 5 páginas. Doorbell kit
Imprimir página
Operating Instructions
Transmitter and ReceiverPairing
Up to two transmitters can be paired with a singlereceiver. One transmitter can be paired with up to two
receivers.
1. Install 3 AAA batteries into the receiver. Adjust the volume level with the volume button if the receiver
doesn't ring while flashing.
2. Press and hold the volume button on the receiver for 3 seconds.The transmitter LED will blink either
green or red to indicate the pairing mode channel.Press any button on the receiver or wait for 60
seconds to exit pairing mode.
3. Press the transmitter button to pair it with the receiver.The"ding-dong"chime indicatesa successful
pairing.From now on the receiver LED will light up with the color that was blinking during pairing with
the paired transmitter.
Chime Selection
There are 52 chimesto choose from with this doorbell kit. Simply press the chime selection buttons
repeatedly to select one you prefer, saving you the hassle of cycling through the whole list if you
accidentally missed your desired chime.
VolumeAdjustment
There are five volume levels in total with the minimum volume level beingsilent. Press the volume button
repeatedly to cycle through the volume levels and set one to suit your needs.
Maintenance and Care
Transmitter Battery Replacement
When the transmitter connection starts to fail, it is time to replace the battery.
Gently pry open the rear cover of the transmitter and replace with the battery of type CR2032 according
to the polarity markings.
Receiver Battery Replacement
The receiver LED flashes in red every two seconds if the batteries are low and need to be replaced.
Open the battery compartment and replace 3 type AAA batteries according to the polarity markings.
Troubleshooting
Problem
The transmitter does not
work.
The receiver does not ring
when the transmitter is being
Possible Cause
Thebattery seal has not been
removed.
The battery is not properly
installed.
Low battery power.
The receiver is not paired to
the transmitter.
Solution
Remove the seal of the
transmitter battery.
Ensure that the coin battery
is
installed
with
polarity orientation.
Replace
the
transmitter
battery.
Pair
the
transmitter
receiver again.
correct
and