Avantes AvaLight-HAL Manual de instruções

Procurar online ou descarregar pdf Manual de instruções para Luz de trabalho Avantes AvaLight-HAL. Avantes AvaLight-HAL 3 páginas. Tungsten halogen light source

AvaLight-HAL Tungsten Halogen light source Operating Manual
SMA plug
On-Off switch
1.
Plug in the PS-24V power supply .
2.
Plug in the connector of the power supply into the socket of AvaLight-HAL.
3.
Connect the SMA-connectors of your fibers to the SMA-plug
4.
Switch on the Halogen lamp with the switch .
The AvaLight-HAL is factory set for optimal power output (medium setting), with an internal jumper the optical
energy can be controlled (see table).
Jumper setting
LOW
MEDIUM (default)
HIGH
The internal jumper settings can be changed, please follow instructions:
Remove screw protection caps on the backside
1.
Loosen 2 screws with philips screwdriver
2.
remove backplane
3.
take out electronics board
4.
Adjust jumper settings according to scheme below
5.
6.
put back electronics board, be carefull not to pinch the
electrical wires
put back backplane, screws and screw protection caps
7.
24-08-04
Avantes
Screw caps
24V Power supply
Starting up
Settings for high power or long lifetime
Optical output
70%
100%
150%
AvaLight-HAL manual.doc
www.avantes.com
PS-24VDC power supply
Color temperature
Ca. 2.700K
Ca. 2.850K
Ca. 3.000K
Exp. Lifetime
> 2.000 hrs.
1.000 hrs
< 1.000 hrs.
Jumper JP1
1