BERNSTEIN VDC-41-MT Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Sistema de intercomunicação BERNSTEIN VDC-41-MT. BERNSTEIN VDC-41-MT 17 páginas.

Restore factory settings

In standby mode, press the SET button on the back of the housing for 3 seconds until you

hear sound (di ...). Then press the SET button 3 times.

Three long beeps (di ... di ... di ...) confirm the restoration of factory settings. Admin code

has been restored to 123456.

Restoring of the factory settings deletes all saved RFID cards and passwords!

Changing of the admin code (the admin code must be 6 digits)

• enter the programming mode,

• select O #, you will hear a long beep (diii ...), the call button will flash faster,

• enter the new + # code, you will hear a long beep (dii ..), light on the call button will

flash slower again.

Adding the public entry code (the public code must consist of 6 digits)

• enter the programming mode

• select 1 #, you will hear a long beep (dii ....), the call button will flash faster

• enter the code number 000-199 and confirm with #, you will hear a long beep (dii ..)

• enter the new code + #, you will hear a long beep (dii ..)

Deleting public entry code (method 1)

• enter the programming mode

• select 2 #, you will hear a long beep (dii ...), the call button will flash faster

• enter the 3-digit number of the entry code (000-199) and select #, then again enter the

3-digit number of the entry code and press #. You will hear a long beep (dii ...)

Deleting public entry code (method 2)

• enter the programming mode

• select 2 #, you will hear a long beep (dii ..), the call button will flash faster

• enter 99 #, three long beeps (dii ...) confirm deleting the password. This method deletes

all previously entered entry codes!

Adding a card (method 1)

• enter the programming mode

• select 3 #, the light on the call button will flash faster

• enter the user number from 000-199 and confirm with #

• put the card close to reader, you will hear a long beep (dii ...)

• to add more cards, apply the next ones one after another. Each subsequent card will auto-

matically be added with user number assigned by 1 higher than previous card (002, 003 etc.).

To finish adding cards, select *

Adding a card (method 2)

• in standby mode, press the SET button on the back of the housing. You will hear a so-

und (di ...)

• put the card close to the reader, you will hear a sound (di ...). to add more cards, apply

the next ones one after another.

• to finish press the SET button or wait 30 seconds.

Removing a card (method 1)

• enter the programming mode

• select 4 #, you will hear a long beep (dii ..), the call button will flash faster

• enter the 3-digit card number (000-199) and select #, then enter again 3 digit card

number and press #. You will hear a long sound (dii ...), the card is removed.