KitchenAid KDRP707RSS01 Manual de instruções de instalação - Página 9

Procurar online ou descarregar pdf Manual de instruções de instalação para Gamas KitchenAid KDRP707RSS01. KitchenAid KDRP707RSS01 16 páginas. 30" (76.2 cm) and 36" (91.4 cm) classic commercial-style dual fuel convection range with steam-assist
Também para KitchenAid KDRP707RSS01: Lista de peças (10 páginas)

Imprimir página
INSTALLA ON
INSTRUCTIONS
Excessive
Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Remove shipping materials, tape and protective film from
range. Keep shipping pallet under range. Remove oven racks,
grates and parts package from inside oven.
2. Remove the 2 screws on each side of the top of the bottom
vent. Slide the vent down and pull toward you. Lay this part to
the side to avoid scratching the stainless steel.
A
A. Bottom vent
B. Remove these screws
3,
Lay a piece of cardboard from side packing on the floor
behind range. Using 2 or more people, firmly grasp each side
of range. Lift range up about 3" (8 cm) and move it back until
range is off shipping pallet. Set range on cardboard to avoid
damaging floor.
1. Move range close to the cabinet opening.
2. Place a rack in oven.
3. Place level on rack, first side to side, then front to back.
4.
If the range is not level, adjust the feet up or down. Turn
leveling leg sleeves to level range and to raise or lower range
to the desired countertop height.
A
\
A. Leveling leg sleeves
NOTE: Oven must be level for satisfactory
baking performance.
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip
bracket to wail behind range.
Reconnect
the anti=tip bracket,
if the range is moved.
Faimure to follow these instructions
can resumt in death
or serious burns to children
and adumte.
1. Choose the correct anti-tip bracket for your installation.
•
If the wall behind the range has no baseboard or has a
baseboard up to %" (0.95 cm) thick, use the shorter
1" (2.5 cm) anti-tip bracket.
•
If the wall behind the range has a baseboard thicker than
%" (0.95 cm), use the longer 13A" (4.4 cm) anti-tip bracket.
2. Locate a stud on the wall behind the range. Measure the
distance from top of rear brace to floor.
A
,%
C
B
A. Rear brace
B. Top of rear brace to floor
C. Top of rear brace
D. Floor
Add 5/16"(0.79 cm) to the measurement from Step 2. This will
allow the anti-tip bracket to slide over rear brace.