Makita DA4030 Manual de instruções - Página 11
Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita DA4030. Makita DA4030 17 páginas. Angle drill
Também para Makita DA4030: Manual de instruções (13 páginas), Manual de instruções (8 páginas), Manual de instruções (10 páginas)
Imprimir página
MAINTENANCE
1. Limit mark
1
2
1. Screwdriver
2. Brush holder cap
•
There is a tremendous twisting force exerted on the tool/
bit at the time of hole breakthrough. Hold the tool firmly
and exert care when the bit begins to break through the
workpiece.
•
A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back out.
However, the tool may back out abruptly if you do not
hold it firmly.
•
Always secure small workpieces in a vise or similar hold-
down device.
•
Avoid drilling in material that you suspect contains
hidden nails or other things that may cause the bit to
bind or break.
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out
003086
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
11