Avanti WCP13IS Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Refrigerador de vinho Avanti WCP13IS. Avanti WCP13IS 17 páginas. Preserver / dispenser

Imprimir página

Setting up the Wine Dispenser Assembly

Start by removing the Argon gas regulator from the shelf by

removing the tie-wraps.

The gas hose (rear hose) should be connected for you by

the factory but in the event the hose is not connected to the

regulator, simply insert the end of the hose into the

pressure coupler, this will create the seal necessary to

allow the flow of gas into the dispensing assembly.

Holding the regulator firmly in one hand, insert the threaded

neck of the Argon gas cartridge into the regulator and turn

clockwise until the regulator pin pierces the cartridge (you

will hear a slight hiss noise), continue until the cartridge is

secured and there is a good seal (no longer hissing).

Hang the regulator on the shelf as shown on the drawing

with the hose to the left of the regulator as shown in Fig. 2.

•Uncork the bottle of wine you want to dispense and insert

the hose from the dispensing assembly.

•Insert the bottle neck into the dispenser assembly until it is

secure. Do not turn the bottle or dispenser assembly as a

snug fit is all that is needed.

•For standard sized bottles, place the spacer pad below the

bottle and raise the bottle height screw by turning it

counter-clockwise until the neck of the bottle is secure and

sealed into the dispenser assembly. *** DO NOT

OVERTIGHTEN ***

** FOR LARGER SIZED BOTTLES, DO NOT USE THE

SPACER PAD WHEN ADJUSTING THE HEIGHT OR

PLACING THE BOTTLE INTO THE DISPENSER

ASSEMBLY.

Test the installation by dispensing a 1 ounce portion of wine.

CAUTION

WHEN DISPENSING OR CLEANING THE UNIT, BE SURE TO HAVE THE DISPENSING

NOZZLE INSIDE THE RECEIVING GLASS OR CUP TO AVOID SPLASH OR SPLATTER.

NOTE:

When the dispensed volume is low or slow to dispense, check the gas and replace the cartridge.

If this occurs after a large amount of wine has been dispensed, allow the gas pressure to normalize

and try again.

If you have recently dispensed large amounts of wine, the gas pressure has not normalized. Allow

the gas pressure in the bottle to normalize and retry to dispense. (Normally 3 – 5 minutes, depending

on the amount of liquid in the bottle and the amount of gas left in the cartridge).

WARNING: Replacing the Argon gas cartridge.

Before removing the empty Argon gas cartridge ensure that all of the pressure has been

released by pulling upward on the manual pressure release valve. (Fig. 1)

If there is no gas released, proceed to remove the cartridge. If there is gas or pressure

released hold the valve open until all gas is released before removing the cartridge.

Fig. 1

Fig. 2

Fig 3