Avanti WDP75 Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Dispensador de água Avanti WDP75. Avanti WDP75 20 páginas. Electronic controlled water dispenser

Imprimir página

Electrical Connection

This appliance should be properly grounded for your safety. The power cord of this appliance is

equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the

possibility of electrical shock.

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning

power and or grounding should be directed toward a certified electrician or an authorized Avanti

Products service center.

This appliance requires a standard 115/120-volt. 60Hz electrical outlet with three-prong ground.

The cord should be secured behind the appliance and not left exposed or dangling to prevent

accidental injury.

Do not use an adapter plug with this appliance.

Do not use an extension cord with this appliance. If the power cord is too short, have a qualified

electrician or service technician install an outlet near the appliance.

Control and Display Panel

For operation of unit, please fill water and make sure water settles inside the water tank, and then

switch on both hot and cold switches at back of unit.

Working Programs:

Energy Saving Program:

When the PROGRAM button is pushed down, it's under Energy Saving Program; The (green) E-S

indicator will be displayed. During operation the (red) "WARM" cycle indicator will be displayed until

the temperature of the water in the reservoir reaches 60ºC/140ºF. Once the temperature reaches

60ºC/140ºF (approximately 4 minutes) the (red) "WARM" indicator will turn off and will remain off until

the temperature of the water in the reservoir drops to 50ºC/122ºF at which time the (red) "WARM"

cycle indicator will turn on and the cycle will start again.