Corsa 14172 Instruções de instalação - Página 3
Procurar online ou descarregar pdf Instruções de instalação para Campânula de ventilação Corsa 14172. Corsa 14172 5 páginas. Cat-back exhaust system, 2006 chevrolet corvette z06 axle back system with single pro-series 4.0” tips, 2006 chevrolet corvette z06 axle back system with twin pro-series 4.0” tips, 2006 chevrolet corvette z06 xo-pipe
7. Slide the now loose flanges on the H-pipe towards the rear of the car
until they clear the studs and pull the entire H-pipe assembly out of
the car. The driver side pipe, leading to the muffler, should slide from
the clamp that was loosened in step 4. (See Fig. G & H)
NOTE: Push H-pipe towards rear to avoid damaging donut gasket.
8. Locate the vacuum lines attached to the outlet side of each muffler, near
the tips. Detach line from each muffler. No tools are required. (See Fig. I)
9. Starting with the passenger side, remove the rear mufflers from the
two rubber grommets holding each muffler in place. Use soapy water
to facilitate removal. (See Fig. J)
10. The muffler is now free and should be removed from the car by pulling
the muffler down while the attached pipe goes over the axle. (See
Fig. K & L)
11. Repeat steps 9&10 for the driver side.
12. Remove the soft rubber end from vacuum line if it did not stay attached
to the muffler assembly. (See Fig. I)
FIG. I
CORSA Exhaust System Installation:
NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure
to follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean hands as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly calibrated Torque Wrench. Using an air impact gun will damage the
clamp and reduce its ability to effectively seal the joint. It may also cause the joint to separate thereby causing
damage to your exhaust system and your vehicle.
INSTALLATION INSTRUCTIONS / CAT-BACK EXHAUST SYSTEM
2006 Chevrolet Corvette Z06 Axle Back System
With Single Pro-Series 4.0" Tips
2006 Chevrolet Corvette Z06 Axle Back System
With Twin Pro-Series 4.0" Tips
2006 Chevrolet Corvette Z06 XO-Pipe
FIG. J
FIG. K
PART NUMBER 14172
PART NUMBER 14164
PART NUMBER 14173
FIG. G
FIG. H
FIG. L