GARDEN MASTER GM1511 Manual de instruções de montagem - Página 3
Procurar online ou descarregar pdf Manual de instruções de montagem para Armazenamento ao ar livre GARDEN MASTER GM1511. GARDEN MASTER GM1511 8 páginas. Sloping roof shed
Também para GARDEN MASTER GM1511: Instruções de montagem (2 páginas)
Imprimir página
STEP 1:
FRONT WALL
1.
Slip
corner door jamb under door as shown. Use
I
the correct opening size by placing on the bottom flange of the door jambs.
Then rivet
channels to tops and bottoms of sheeting.
F
2.
Outside: Rivet channel at corners and every 2nd rib between and through door
jambs and spacer.
3.
Inside: One rivet per sheet at each end up through channel underside and
through door jambs and spacer.
Rivet padbolt to the outside of door using wide flange rivets supplied.
A Door jamb fits inside bottom channel.
B Door spacer fits inside door jamb but
A
B
keeper
washer
Rivet
Padlock keeper assembly
H
F
SCAN TO
WATCH OUR
ASSEMBLY VIDEO
HERE
FITTING CHANNELS
The higher side of the channel goes to the
inside of the shed. It is very important to
include the rivets on the underside of all the
channels as they are structural
(except roof channels).
OUTSIDE
!
If you choose to vary from these instructions your
warranty will be impaired.
to the outside of bottom channel.
I
CHANNELS WITH CUTOUTS
The cutouts go to the inside of the panel to
allow easy fitment of the end walls
on assembly.
INSIDE
door spacer to determine
H
Channels will come short of the ends of the
sheeting by 10-15mm on all panels.
D
B Drill through to the underside.
Rivet top and underside.
TOP
BOTTOM
i
If you need advice, call us
or email us at [email protected]
YOU WILL NEED:
1 x 'Z' door jamb attached to a channel
I
for the corner door jamb
1 x 715mm wide sheet with door
D
and door jamb attached
1 x 1515mm top channel
F
1 x 1515mm bottom channel
H
2 x 793mm door spacers
F
H
A Drill and rivet here.
A
GARDEN MASTER TIP
To hinge the door on the opposite side,
simply put the top channel on the
bottom and the bottom on the top.
Put the padbolt on the door before
erecting the panels. It will stop the
door swinging around!
FREE
0800 807 433
on
B
3