AIRFUSION LD-CD52BN/WH Manual - Página 2

Procurar online ou descarregar pdf Manual para Ventilador AIRFUSION LD-CD52BN/WH. AIRFUSION LD-CD52BN/WH 19 páginas.

CONGRATULATIONS ON YOUR PURCHASE

Congratulations on purchasing the latest in energy saving ceiling fans. This fan runs on DC (direct current) power

which gives it the benefit of being super energy efficient whilst still maintaining high volume air-movement and

silent operation.

Energy Saving - The DC motor is the latest technology in fan design. Its highly efficient motor saves up to 65%

energy than ceiling fans with traditional AC motors.

Silent operation – this DC fan motor is programmed with a stabilized current which efficiently reduces motor noise.

Low operating temperature – The DC power is managed effectively which brings down the motor operating

temperature to less than 50degs. This results in a much cooler motor than a standard AC fan and increases the

longevity of the motor.

6 speed remote control, regular AC ceiling fans usually come with only 3 speeds, this DC fan comes complete with a

6 speed remote, which give greater choice of comfort levels.

The information contained in the following pages has been prepared to ensure you of trouble-free operation of your

Ceiling Fan .

To ensure the success of the installation be sure to read the instructions and study the diagrams thoroughly.

For your safety, all electrical connection and disconnection must be performed by a Licensed Electrician, in

accordance with the current wiring rules AS/NZS 3000.

All electrical work should only be undertaken after disconnection of the power by removing fuses or turning off

the circuit breaker to ensure all pole isolation of the electrical supply.

Make sure that your installation location will not allow the rotating fan blades to come into contact with any

object and that there is a minimum clearance of 30cm from the blade tip to the wall or nearest object. Please

note that the bigger this clearance is the better the airflow from your fan will be. Ensure the blades are mounted

at a minimum height of 2.1 meters from the floor when the fan is installed.

The fixing point for the fan must be able to support a weight of at least 30kg. If you are mounting the fan to a

ceiling junction box, the box and it's fixing must be able to support the moving weight of the fan and must not

twist or work loose.

The fan must be earthed.

Do not connect the fan motor to a dimmer switch. This may give an unsatisfactory performance (motor hum)

and cause damage to the motor. Only use the supplied fan controller.

It is not recommended that ceiling fans and gas appliances be operated in the same room at the same time.

The fan must be turned off and stopped completely before reversing the fan direction. This will prevent any

damage to the motor of the unit or controller (if installed).

10. Do not insert anything into the fan blades while the fan is operating, as this may cause personal injury, damage

the blades, and upset the balance of the unit causing it to wobble.

11. After the fan is completely installed make sure that all connections are secured and tightened to prevent any

noise problems from loose parts.

12. Because of the fan's natural movement, some connections may loosen. Check the support connections,

brackets and blade attachments twice a year to make sure they are all secured. If they are loose, tighten with a

screwdriver.

Note: The important safeguards and instructions given in this manual are not meant to cover all possible conditions

and situations that may occur. It must be understood that common sense, caution and care are factors, which

cannot be built into any product. The persons caring for and using the unit must supply these factors.