Jands Stage Manual - Página 13

Procurar online ou descarregar pdf Manual para Misturador de música Jands Stage. Jands Stage 17 páginas.

Working with Chases

The Stage 12/24 has the ability to chase through all or selected channels in

either ascending or descending order.

The Chase Controls:-

The chase controls are used to set the speed, direction, level of the Chase

output, assign channels to the chase, and enable the output.

Rate Fader

The Rate fader can be used to speed up or slow down a Chase.

Pushing it to zero will slow the chase to a STOP; pushing it to full

will increase the speed to the maximum speed of 1000 beats per

minute.

Please note that the chase is automatically stepped from the audio

signal when a plug is inserted in the Audio Trigger input on the back

panel.

Chase Direction

The Direction button is used to set the direction of the Chase. Push the

button to change the setting. With each press of the button the

direction changes from either forward (ascending, LED off) to

reverse (descending, LED on).

Assign Button

The Assign button is used to change the console from normal to chase

assign mode. When in chase assign mode (Asn LED on), the channel

mimic LEDs show which channels are currently assigned to the

chase; pressing a channel flash button alternately adds or deletes a

channel from the chaser.

Please note that when the console is first turned on, all channels are

automatically assigned to the chaser.

Go/Cue Button

The operation of the Go/Cue button is changed by the position of

configuration DIP switch 3 accessible from the back panel. However,

in either mode when the Go/Cue button is pressed, the Chase is reset

to the lowest step if forward mode is selected or the highest step if

reverse mode is selected.