HIKVISION 1006KI Como utilizar - Página 3

Procurar online ou descarregar pdf Como utilizar para Hardware de rede HIKVISION 1006KI. HIKVISION 1006KI 5 páginas. 485 control back-end gui4.0
Também para HIKVISION 1006KI: Manual de instruções (9 páginas)

Imprimir página

4. Then you can see this page. The Add. Bit0 is the Broadcast address which means if

you choose this channel, you can control all PTZ in the same time. But if you want

to control the different PTZ, you need to set different Add. Bit for all of them. (You

should notice that this Add need to match the address on the device.)

E.g. If the SW1 switch on the PTZ 1 is 1, we need to set our Add. Bit as 1 too. And

normally the default Baud Rate is 2400. For the Protocol, you can choose the

HIKVISION. Then press OK button to save the setting. Then we have finished 1

PTZ's setting. You also need to configure another 4

Notice: I have confirm with R&D colleague that all kinds of analog speed dome

have the DIP Switch. So you just need to find it. And make sure PTZ have the

different address and do the setting as I mentioned above.