Empire DV-55SPP Instruções de instalação e manual do proprietário - Página 12
Procurar online ou descarregar pdf Instruções de instalação e manual do proprietário para Forno Empire DV-55SPP. Empire DV-55SPP 20 páginas. Fan type direct vent wall furnace
Imprimir página
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1. STOP! Read the safety information above.
2.
Set the thermostat to lowest setting.
3.
Turn off all electric power to the appliance.
4.
Remove control access panel (lower front panel).
5.
Turn gas control knob clockwise
6. Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information above. If you don't
smell gas, go to the next
step.
7. Remove the pilot access
cover located on the
combustion chamber.
8. Find pilot - follow metal
tube from gas control. The
pilot is located between the two burner tubes behind the
1.
Set the thermostat to lowest setting.
2.
Turn off all electric power to appliance if service is to be
performed .
3.
Remove control access panel (lower front panel).
Page 12
LIGHTING INSTRUCTIONS
causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
to "OFF."
TO TURN OFF GAS TO APPLIANCE
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it; call a qualified
service technician. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been under
water.
pilot access cover.
9.
Turn gas control knob counterclockwise
"PILOT."
10. Push and hold red reset button down completely and
repeatedly push the ignitor button until the pilot burner
is lit. Pilot may also be lit with a match. Continue to
hold the red reset button down for about one (1) minute
after the pilot is lit. Release button and it will pop back
up. Pilot should remain lit. If it goes out, repeat steps 5
through 10.
• If button does not pop up when released, stop and
immediately call a qualified service technician or
gas supplier.
• If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call your
service technician or gas supplier.
11. Replace pilot access cover.
12. Turn gas control knob counterclockwise
"ON."
13. Replace control access panel (lower front panel).
14. Turn on all electric power to the appliance.
15. Set thermostat to desired setting.
4.
Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
5. Replace control access panel (lower front panel).
to
to
12431-7-0107