Garden Treasures F40979AA Instruções de montagem - Página 2

Procurar online ou descarregar pdf Instruções de montagem para Fonte exterior Garden Treasures F40979AA. Garden Treasures F40979AA 3 páginas. Arch mosaic fountain

Assembly Instructions
1.
Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Place the basin flat on a horizontal ground. (Fig.1)
4.
Insert the water supply tube extending from the underside of the top fountain into the outlet on the pump. Then
place the top fountain onto the basin securely and levelly. (NOTE: Place the pump to the pump chamber and
align the plastic rods on the bottom of the top fountain with the holes on the basin). Route the pump power cord
from the back of the fountain via cord slot. Then attached the trap door over front of the pump chamber. (Fig.2)
5.
Locate the wire netting to the central part of the basin and directly under the faucet. Fill the basin with clean
water. The water level should be approximately 10 mm below the wire netting. (Fig.3)
6.
Plug the power cord from the pump into the Ground Fault Circuit Interrupter (GFCI) outlet. Turn the power
source on. The product will start to function as intended. If water is splashing outside the fountain, rearrange the
wire netting by adjusting its position. (Fig.4)
7.
To eliminate the possibility of water damage to areas around your fountain, check for leaks and excessive
splashing after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
that will not be damaged should the area come in contact with liquid.
8.
Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
9.
Check the area around your fountain on a regular basis to ensure that there is no leakage.
Pump Maintenance Instructions
Regular cleaning of the pump is necessary.
Keep water clean to prolong the life of pump.
Clean pump when it is dirty or when a drop in performance is detected. Use warm, soapy water and a stiff brush
for heavily stained surfaces. Do NOT use harsh chemicals, as this will damage the surface finish.
Failure to clean the pump will result in overheating and voiding of the warranty.
Use a filter on pump if available.
Disconnect the power and empty the reservoir if the fountain will not be used for an extended time.
Do NOT operate fountain in temperatures below 41°F (5°C). Freeze damage may occur. If the fountain is kept
outdoors in freezing temperatures, make sure all water is removed and the unit is completely dry.
To disassemble pump for cleaning:
1.
Always disconnect pump from the power source before cleaning.
2.
Remove the inlet screen and impeller housing.
3.
Remove the impeller/rotor assembly by gently pulling on the impeller blades.
4.
Use a soft cloth or brush to clean the impeller/rotor assembly area inside the pump.
5.
Clean the inlet screen, impeller housing and impeller with warm, soapy water.
6.
Reassemble the pump and check for proper operation.
Hints and Troubleshooting
If the pump operates but there is no flow, check to make sure that the pump is fully submerged.
If the pump operates but there is no flow, check the supply tubing for kinks and correct.
If the pump operates but there is no flow, and if the pump is submerged and there are no kinks in the supply tubing, lift the pump out of the water.
Remove supply tubing at pump outlet and clean tubing inside and out if necessary. Put pump back into water (outlet side up). Once water begins to
flow, reattach the supply tubing.
Pump is replaceable with model # PT-707MIX UL. Call Customer Service at 866-728-6187 for replacement parts.
SAVE THESE INSTRUCTIONS!
Note: Each Garden Treasures fountain product may have variations in texture, finish and appearance from unit to unit. This enhances the beauty of the
product and makes each Garden Treasures fountain product unique. Some products and finishes are intentionally weathered or worn in appearance for
aesthetic design.
1- Year Limited Warranty
(Valid in USA and Canada only)
Peaktop warrants this product to be free from defect in material and workmanship for a period of one year from the date of original retail purchase and
as set forth below.
Repair/ Replacement Warranty: Pursuant to this Limited Warranty, Peaktop will, at its option,(i) repair the product using new or refurbished parts or (ii)
replace the product with a new or refurbished product. In the event of a defect, these are your exclusive remedies. For purposes of this Limited
Warranty, "refurbished" means a product or part that has been returned to original specifications.
2