Avaya 3606 Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Telefone IP Avaya 3606. Avaya 3606 16 páginas.
Também para Avaya 3606: Manual de referência rápida (1 páginas), Manual do utilizador (16 páginas)

Imprimir página

Avaya 3606 Wireless IP Telephone User's Guide

Removing and Replacing the Battery Pack on the

Wireless IP Telephone

To remove the Battery Pack, press down on the oval button above the Battery

Pack on the back of the telephone. Slide the Pack toward the bottom of the

wireless telephone until it stops, then lift up.

To replace the Battery Pack, first properly align the top of the Battery Pack with

the arrows on the label on the back of the wireless telephone. Gently press and

slide the Pack toward the top of the wireless telephone until it snaps into place.

You should not have to force it against the wireless telephone.

Take care not to short the Battery contacts on the Pack with metal objects such as

coins, keys or paper clips. Shorting the contacts can cause permanent damage.

Charging the Wireless IP Telephone

Chargers are shipped with the appropriate power supply for the site's location.

Connect the Stand or Charger to an appropriate wall outlet via its power supply

and it's ready for use. Chargers operate in a 50 degrees to 85 degrees F (10

degrees to 30 degrees C) environment. Do not expose them to freezing

temperatures or direct sunlight.

The Dual Battery Charger Stand

The Dual Battery Charger Stand is a two-slot desktop charger designed to charge

the Nickel Metal Hydride (NiMH) Battery Packs required to operate wireless

telephones. Full charging is accomplished in approximately two hours.

Only NiMH Battery Packs with a YELLOW label on the handset contact side may

be charged in the Dual Battery Charger Stand. Older Battery Packs with a

GREEN label will not charge. If the indicator light is fast flashing with a Battery

Pack or handset in the slot, check to make sure the Battery Pack has a YELLOW

label.

The Dual Battery Charger should not be used to charge Nickel-Cadmium (NiCd)

Battery Packs.

When you are not using your wireless telephone, keep it turned off and in the

Stand.

Do not place anything in the Dual Battery Charger other than the wireless

telephone. You might damage the contacts. Bent contacts can keep the wireless

telephone from charging.

Issue 2 February 2003